Viewing all customer Discussions for:

26-040 Pivot Bar, 3"

Please provide me with the alternative parts

I need to replace a broken balance in my window. Attached are the photos. Please let me know which part should I order?

Part pivot bar

Hi, none of the 6 double hung vinyl windows in the house I just bought will stay open. The spiral is the same for all of them. 31" long, red tip, looks like the s400. In a few of the windows that I managed to force up, the red tip was shattered. There's grease everywhere. The windows are marked 198 ... (cont.)

Window installed throughout house new construction in 2001. Balanvcer apri g has a "8" stamped on spring. I need 3 complete r/l setsMI windows were used in all of the new homes in our development. Several of these balances are broken (springs snapped). The windows all appear to be the same size. ... (cont.)

Good Morning, if you have 4 of them i would like to have them if they are same sizes as the one on the paper that i sent you Thank you!

So these shoes are 3/8" x 1" x 2". I ordered the 15-045 and apparently to bar does not fit into the pivot shoe. It is 1/4". The opening aon the actual is larger. So i need something differnent so the shoe will accept the bar. The bat on existing is 1/4" but does not fit into the 15-045. It is 3 1/4" ... (cont.)

On the coil spring it shows 5EH. I could not get all the parts out of the window for measurements

Need to replace on 4 windows

This is for a customer of ours. The sash size is approximately 30" x 30". The sash doesn't currently stay up, it slides back down after lifting it up. We would need 2

I don't know the window is called I couldn't find the stamp when I did take it out. Need help finding this plz.

Searching for sash clip; very simple looking... like a miniature piece of channel (dimensions in photos). Opposite side rusted and broke off. Did not see in your selection, but I may have overlooked it. Thanks!

I need to get the part that I would assume is a metal pin for the window tilt. I have attached the photo of what it attaches to but as you can see, it has rusted away. I am not sure what is suppposed to attach the part shown to the window. It currently does not stay in on that corner when you open t ... (cont.)

Can you guys identify and supply replacement?

Please narrow down my search for these two parts i need 10 of each3" length7/8 width

I need 14 red tip spiral balances. They are 26" tube...3/8" wide tube . Also 6 green tip spiral balances 26" tube 3/8"wide tube . 10 pivot pins . 4 tilt lashes 2.5" long by 5/16 wide . Thank you Jim Schuler

I need some window parts. To me the balance looks the same. This window is a little different than the others. It's curved at the top, but it's the only one with a label. Can you help with this?

Need part and hopefully some insight on how to remove a rusted pivot bar broken inside the sash frame

There is no markings on this so ive had trouble finding a replacement, between 26 -271 and 26-379 they seem to be best options but not an exact replica.

Hi, I need both the left and right window equilizers. Thank you, Scott