Viewing all customer Discussions for:

26-041 2" Pivot Bar, Keller

There are no markings anywhere.It's a condominium complex. "The Pines" It was built in 1985 in SHOWLOW, AZ 85901. Are you able to figure out what brand these windows are? I would need the hardware for two windows left and right side. Tilt locks, tilt guides on bottom of tilt window, left, and right ... (cont.)

Rebuilding some windows and recently purchased Pivot Retainers (Product Code: 15-056) that fit the shoe. I now realize the shoes are not staying in place because of wear and a couple are broken. I've attached photos of the shoes and the pivots. Please let me know if you have something that will w ... (cont.)

Just wondering if you have this part

Hello I need 14 of these top locks and 14 of the bottom pin/ lockHave a great day and thank you!!!

Pic #1: What type of latch do I need Pic #2: What looks like made of cast-iron... is a broken knob that would fit into a pivot shoe...

Window part that prevents the window to slide down/hold after it is opened. Please help identifying the part. Thank you.

I am looking for a specific window part that appears to be a foot well matched with pivot shoe for a sliding window. The part I need has the following dimensions: - Length: 5 centimeters (approximately 2 inches) - Width: 5 millimeters (approximately 0.2 inches) I have attached photos of my broken pa ... (cont.)

Hello, I have attached a picture of a sash spring. Unfortunately, I do not have a picture of one installed. They do not have a colored tip at the end to represent spring strength and they are 29 inches long and 3/8 inches wide. Also, do you have a exploded view of the attachment to the sash? The sma ... (cont.)

I need replacement tilt latch's And I need the part the goes on the bottom of the window that connects the balancer to the window. These windows tilt in so the window rotates on this part as well.

I have a customer with a heavy aluminum window that has broken slide bolts and swivels. I do not know the make. Can you help me identify the parts

Looking for parts for my older model windows (brand name is Living). Issues with the spring and cylinder housing on the sides of the windows. Also, issues with the bottom clip (on the left and right side) that holds the window in place when it's raised.

Nothing on windows to identify. Old house

I am looking for this pivot bar for my tilt window. It is aluminum(steel) and is 2 inches long. it only has one hole in it to mount in my window. I can't get a better picture of it. Sorry about that. Can you help please. The part is from the 1980's.Thank youGary K

I'm missing the parts that keeps window in place

Window weight 17.2 pounds Tube length 29 inches Tube diameter 3/8 of an inch Pivot shoe 3/8 of an inch I want to replace the parts on all my windows.

Tilt out window metal guide good one shown other side corroded and broke. I need the little metal guide that slides into the spring balance.

Hello, I have the same windows as this post. I need to purchase the pivot bar noted but, I also need the other metal part that goes between the channel in the sash and the pivot bar. I have included pics. Please help.

Window won't stay open & from comparing to other windows in The house the piece in the picture is broke. Do you sell the replacement parts?

This is from a spiral tilt window. I bought the sash last week. I need a set of theses I think it's a guide for the shoe.

Hello. I need replacement block & tackle sash for my Milestone single hung Series 1000 winodws. Need 04 of them in total. the metal piece is 23 inches overall length, 9/16 - 5/8 of an inch wide and 1/2 inch deep. The metal piece has a stamp indicating '22C' on it.