Viewing all customer Discussions for:

79-126 Right 7/64" Recessed Door Offset Pivot Set, Amarlite

I do not know the make of this door. I've purchased 2 or 3 types I can't seem to find the correct one

The door is an Amarlite, thank you 36x81.5, left hing, red new hinges and thresholdDoor sits flush in frame, not recessed 1/8”

Please help identify this door pivot. It is on a commercial glass storefront about 30 years old or so. Thanks

Hello, I am looking for replacement commecial door pivots. The photos are attached. Thank you for your assistance.

bottom hinge was scrapping so i lifted the door and shimed with washers ,but would like to fix it right not sure the correct hinge .

I need these parts, and not sure where to get them from

Hello the closest match I can find was product code 79–131. Is this correct?

Need to replace the top pivot hinge.

Looking for a pair of new door pivots for the threshold bottom mounted pivot and top frame mounted pivot. I also have another door with a similar set of pivots that I will need help identifying. I can only upload 5 images per post so I will wait to share the other door when I am reached out to. tha ... (cont.)

Hello, I need to replace the hinges on my door. Can you please tell me what hinges I need? My door is 12 years old +/- Thank you, Greg

I'm looking for the upper and lower hinges right and left side for this store

Need to know what swing is technically is and part Thanks Adam

I need help finding this part!

The hinge are the left side of your facing the door from outside and right side when your facing the door from inside. What are the hinges I need, I think the hinges are bad because if I raise the door a little they were fine for 10 minutes, after the door rubs against the threshold ... (cont.)

is this enough to id the hinge needed? If not what else would be helpful? I am hoping to not have to remove the hinge but if that is the only way then I will. Thanks

Hey I need this piece for my door I have kanweer door. I dont know this is left hand or right hand.

Are these type of hinges available?

I have an exterior entry door at our shop that is dragging on the threshold, and I would like to replace the pivot hinges. I do not know how to identify the manufacturer of the door. The building was built in the early 1970's and there is no marking or names on the door frame or door that I can fi ... (cont.)

I am trying to replace pivots on a convenience store. Door is Amarlite. These pictures do not seem to match the pivots that are shown for Amarlite.

Do you have these pivot hinge?