Viewing all customer Discussions for:

26-083 Pivot Bar, 2-1/2"

The photo of the broken piece does not show the round metal part that the tilt part in the window slides into. There is no markings I can find. I looked online and couldn't find anything that looked like what I sent. This is a tilt in window.

I need this hope you can help me thanks

This part holds the upper window when it tilts out. The first picture is what broke off in the second picture. Do you have a replacement?Linda

Hello, this piece on my window broke I believe is the window tilt retractor not sure exactly. I also added a label that's on my window. It is a single coil.

Hello, I need to order three parts a shoe pivot, pivot and a pivot holder. Could you help me find the correct part number? Thank you, This is the best picture I have of the pivot bar. I hope this will work as I am a couple hours away from the house. I did pull an entire pivot shoe out that I c ... (cont.)

Do you have these balance shoes for a 2001 double hung window

I'm not certain if these pictures are adequate but we have a client that needs at least 4 window sash pulley systems replaced and thought I would check with you folks as you have helped me in the past.

Bar is 21/8 overall. From should back-15/8. 1/4 wide 3/16 thick.

I would like to replace parts in several windows the locks say Prism and the labels have 1258 C15 . Is that enough information for top and bottom replacement parts?

I have 3 different sizes of Simonton vinyl windows I need to replace the broken balances. They have no markings on the coil springs. The first one has a top sash weight of 9.6 #'s and the bottom weight of 10.4 #'s . The second one has a top sash weight of 7 #'s and the bottom weight of 7.6 #'s. ... (cont.)

Have no ideal what this part is called. It mounts to bottom corner of window and the other end fits inside a square piece that slides up and down the track on the outer frame

I appear to have a Prism Window, as identified on the window lock. The left hand side of the window balance is stuck in the groove and separated from the post connected on the window. Appears to have a double coil spring. I need to get the specification on what size coil spring i need to order fo ... (cont.)

Looking for correct replacement balancer assembly as pictured, i realize the Simonton parts are obsolete, hoping you guys have a direct replacement. Really hoping to just unscrew the old and put in a new, not looking to rebuild or reconstruct anything. Can NOT find a "weight code" stamped anywhere, ... (cont.)

The only discernable marking is "27B". No surprise that it's 27" long. Can you match it, and does the manufacturer include the pin that engages the cam mechanism? One of the two on my window sash rusted away. Thanks! -Ron

I need to replace the balance coils

The parts removed from a 'Certain Teed' window. On the spring where is mounted with a screw is marked 335 and 336. On the "L" shape plastic bracket marked "Certain Teed' Measurements are 1 1/2 X 7/8 for both parts without the spring. Spring width 3/4.

I am trying to get a coil balance to go onto the coil support. I purchased 4 of each and had no problems with 3. Could either the coil balance or the coil support be the wrong size.

The plastic piece broke in half. The other half is still in the window. Do you have replacement part? If so this is the left side of the lower window.

Single coil window balance (I think that is the correct term for the part(s)) for tilt out vinyl windows. Within the case with the philips screw is wide coil that allows the lower part of the window to open and close smoothly.

That's for a Simonton window.