Viewing all customer Discussions for:

26-120 LH Top Tilt Latch, 2-1/8"

I'm unable to correctly identify the appropriate latch to replace my climateguard window latches

Windows were installed 1997 (vinyl slider ) left hand side part needed. 3.25 long, 1.4 wide, depth .4 inches. There is a number 2634 on the part.

This is one of two parts on each window which enable the window to be easily removed from the frame. I haeva byuildinf full of these windows, about 17 years ld and these parts are failing. Other parts and the units are fine.

Please see the two scans showing the exact tilt latch that I need, though I need a right one missing from my window. This accompanies my samples, S23992 and S23987.

Need 2 of these surface mounted latches

I need 6 lefts, and 6 rights. The hole space is 2 1/8". Overall length is 3 1/16th. Do you have them ?

Back in 1997 we did a renovation which included all new windows.... they are ALL wood frame and sash... single (lower) hung & tilt mechanism So, here are the following main issues I have.... First main issue is the PLASTIC tubing around the spiral balances have dried up, cracked, disintegra ... (cont.)

Hi, wow cool you can send the picture in... i have this part witch from screw hole to screrw hole is 2 and a 1/4 inches

Hello, I am looking for 10 of these window parts (for 5 windows). Number on the back is 2634. I've attached photos. Hope you can help! Thanks, Melanie

Can you please tell me the replacement part I need to order for this window latch? I need a left and a right one. Thank you,

need theses parts

Looking for replacement latches for those shown in the photos. I think they come from Ducana windows from about 15-20 years ago.

Hello Need help replacing this damaged latch. The latch is beige in color. It's 2 15/16" long. The screw holes are 6/16" in diameter. I oredered 26-120 and 26-078 and they both are too wide for the window sash. And the triangle part that sticks out on 26-120 and 26-078 are too big to f ... (cont.)

Hi there, I

I have pictured thermal gard windows. I need several replacement parts of all three plastic sash lifts plastic sash keepers metal locks any assistance would be appreciated!

Hello, I need 2 of these latches, the only thing that the window says is Superseal, 1990. Dave H

Hi, I cannot seem to match my size to a part number. Hoping you can help. Ken

only marking is on Tilt Latch: Poly-Tex, Pittsburgh, Penn. tilt Latch is 3 1/16" x 1 5/16" Two screw holes of different sizes and offset. Photograph shows top and underside. Pivot bar is 3" x 1/4" and has two slots for attachment screws. I appreciate your help in identifying and acquiring th ... (cont.)

See photos. Need the left and right. Part is about 3" long, screw holes on 2" center. The finger hole is oval. The screws are offset away from the edge of the window.

Hi, I spoke with A representative yesterday at your store and I am not sure what type of part I need to fix my window. The make of the window is Patriot. I need a coil balance for it. The attached pictures should give you an indication of what type of coil balance I need. Can you please take a lo ... (cont.)