Viewing all customer Discussions for:

81-266 1-1/4" dia Roller And Axle Kit

Dimensions 2-1/8" longer 1 3/8" high & 3/4" wide

I'm looking for a set of rollers. The current ones are no longer sliding smoothly and don't hold level. The only marking I can find on them is "DEL MAR ENGR." "PAT. PEND." They look to have a single Nylon wheel, and locking tabs. The hole drilled in to the side is from the previous owner who install ... (cont.)

Swisco Needed the bottom rollers for a Stanley Double Glass sliding patio door. 60 x 80" Low E,

I need 2 glass door rollers. I have not been able to find them. Attached is a picture of them. Do you have these in stock?

Sounds like I have a broken wheel as the door grinds a bit when moving. Do you think parts are available and instructions on how to replace it? Thank you for your time.

This sliding glass roller is off a patio enclosure door. The roller was likely nylon but is destroyed and not sure what the diameter is, possibly 1 inch. As seen in the picture, it appears to be about 2 1/8" in length and 5/8" wide. There is an opening at the end above the adjustment screw that a ... (cont.)

I am repairing two 60 year old aluminum Patio doors on my home. It is a mid century home and we want to keep the doors. The steel ball bearing rollers are 1.25 inches in Diameter. The center hole is 1/4 inch diameter. The roller is 7/16 wide, with the groove approximately 5/16 inch wide, inside ... (cont.)

Hello, please help us identify this roller and if you have it available for sale

wondering how to remove peach tree citadel slider to replace wheels may be stripped

Hello, I'm hoping to find a replacement for the damaged part that you see in the photos uploaded. Any help would be very much appreciated... The stamp on the wheel is Kilian - Syracuse - Toronto and that's all I can decipher as it is mangled due to the size and weight of the door 60"w x 78"h Weight ... (cont.)

Looking for a set of patio door wheels that match my photos

Hello! If you recognize this part, it belongs to sliding doors of some kind. See pictures. There is no other outer casing for this that I have seen. The dimensions may not match exactly on wheels. See attached picture

Hi,I'm trying to find a set of replacement rollers referenced in the subject line. The house was built in 1957, and the doors may be original to that year. They are just a friction fit in each end of the frame with a height adjustment screw positiooned vertically from the bottom.I've attached a few ... (cont.)

Screw hole on top, 1-3/8" distant from back edge. Wheels are 1-1/4"

Very old,sliding glass door rollers (2) that fit aluninum frame.

Hi, I would like tu buy 4 rollers and i need to know which rollers will fit. Please see the photo and measurements. Thank you.

This is a tandem roller on a Revere sliding patio door. Door is one of two sliders with 2 solid panels. Unit is 12 ft wide and 8 ft tall. Approximately 12-13 years old. Tandem wheel unit looks like your 81-156 model with end adjust. The 81-156 shows to be 1.5" width/tall on the carriage unit wher ... (cont.)

Looking to replace these rollers, are you able to assist?

1 and quarter inch wheel

Hi could anybody help me identify which part I need to order to replace the sliding glass door roller assembly? The roller assembly is in two pieces both made out of aluminum it has a 1 and 1/4 inch steel wheel. Thanks for any help identifying