Viewing all customer Discussions for:

81-266 1-1/4" dia Roller And Axle Kit

Am having a hard time sourcing the correct roller replacement. I have tried most 1 1/2 replacement and end up being to tall to fit and have tried most 1 1/4 rollers and they are to small for the opening. I took a tape measure and the opening and replacement past that came out was more like 1 3/8 i ... (cont.)

No id numbers all metal including roller 8-10 mm x approx 40mm approx 50 years old

Body Measurements 3 1/4" long 1 7/16" tall 13/16" wide

Can you help me with the part number to match the transom door roller for the attached pictures?

Closet door is brass and glass. Not sure of the plastic roller is replaceable or if I need a new unit altogether. Case is appox 0.58" wide, 2.32" long (looks to be adjustable), and 1.05" tall. Unsure of roller diamter but has a marking of C-Co on it if that helps.

I need one wheel like that one

Unable to locate new roller assemblies. Please provide part number and manufacture if you can. Also cost please. Thank you.

do you have this part or know where to find this part? I called Tampa Bay Sliding Doors & Windows & they said you carry just about everything. thanks! Sharon

Would you have this type of roller. They are quite small. I have to remove the door frame to access these. Thanks Kevin

Looking for 2 replacement wheels for a sliding glass door

Two rollers marked with Product of Del Mar Eng Co Long Beach CA Pat 3,670,357 Both have failed and the door barely moves. Need to locate and purchase two rollers.

From circa 1995 Marlin Windows, in California. Marlin Windows has undergone ownership changes since then so they recommended I use your service. Thanks!

I am needing 4 new rollers per the dimensions found in the photos. I am wondering if you would have an email that I could send photos because the "Add Photos" above doesn't seem to be working. I now noticed your email below - could i send photos to help@swisco.com?Thanks,Dave

Hello! This door is 50 years old, and I wouldn't be surprised if these were the original rollers. Once we cleaned them up from erroneously applying WD-40 (using the proper dry rub now!), they work pretty well except the bearings on the front roller are shot. There are no markings. The steel whe ... (cont.)

Hello, this Alenco door is about 40 years old. There appears to be a screw coming down from inside the bottom edge of the door holding the wheel casing in. I do not want to disassemble my door without a replacement part. It has a single metal 1 1/4 inch roller, length 2 1/4 inch long, 1 1/4 inch ... (cont.)

Greetings, The roller assembly picture attached has 1 1/4" dia. steel wheels, 5/16" width and 1/4" dia. hole. The 1 1/4" wheel repair kit that you carry, what is the weight specification for the bearings? Thank you, Mark

Trying to identify wheel.

Hi do you carry these or do you know some where I can get them? Thank, Bob

Dimensions: 3/4" width, 1 3/4 Height, 1 1/" aluminum bearing

I received a replacement roller from you last week. It was order #2337837 and included part number 81-018. It is not a match to the TRUTH roller. It is close, but the tabs to attach it to the door are flush with the assembly, while the Truth assembly tabs are lowered from the assembly. The ones I re ... (cont.)