Viewing all customer Discussions for:

58-135 25ft Bubble Seal, 3/16" x 11/32"

I am looking for some weather stripping as shown in the attached pictures for windows. These are the same windows I purchased the Spiral Balances through Swisco.

Hello, I need to know if you carry this item or of you have something similar, please.

I am looking for a replacement part for the weather seal of the terrace door. As you can see from the pictures, the width and height is about 0.25 inch for the weather strip. Can you help me to identify what would be the replacement part for this? Thanks.

This is the vertical seal between the 2 doors. I cant seem to find any info on whom the door is made by.

I am looking for replacement weatherstripping for certainteed windows purchased in 1995. There is a rigid piece approximately 5mm wide that slips into a slot on the window frame and then a flexible part that resembles a sideway J approximately 9.6mm wide that actually seals the window when closed. ... (cont.)

The size is. White plastic which slides into rail slot 1/4 inch. Attached round bubble 1/2 inch diameter. Need 11 lineal feet for one five foot and one six foot door opening. Hans

Doors are Kawneer maybe 30 years old. Double 36''w 84''h

25+ Old Alenco window bottom seals

Attached are some photos of weatherstripping that I'm trying to replace. The windows are 30 years old. I believe they are Weather Shield brand. The snap in ledge of piece is about 3/16" and the seal part is about 5/16" measuring from the longest points of the oval. Any guidance would be appreciate ... (cont.)

Hi, My in-laws are trying to find the brand of the windows in their house. The builder has passed away and the original owner does not remember and we have found no identifying labels anywhere. The crank out hardware is TRUTH hardware and the only other name was on the crank which is SEMCO which cou ... (cont.)

I'm looking for the lower T-slot bubble seal and possibly for lift pins for some windows which I believe are Jeld-Wen dating back to 2003. The lift pin itself is 1/2" long by 0.050" diameter. The base portion is 0.440" diameter. This pin appears to screw into the window's extrusion. If you have ... (cont.)

Hello a have to replace this weather gaskets for a customer please get back to me as soon as possible just need someone to tell me the code of each gasket so I can Order, I believe they are Kolbe doors and need the complete set. Thanks Peter

weather seal on bottom of window

I have the above storm door and noticed that the bulb weather stripping along the top of the windows has deteriorated and needs replacement but I'm not sure which one to use.

Looking to replace bottom gasket and seals on the side windows also need the plastic part that The window attaches to

This was used for my transom door on my Tiara boat. AmersburyTruth Pt. 32021 doesn't make it anymore. Looking for an equivalent.

The middle strip cross section in the first photo (0600) us shown installed on the side casement, perhaps where the doors meet when closed.

Ok last one I hope. What type is this?

I have Hurricane windows. 1) I need 6 1/2" non tilt Channel Balances that are 23" long, Part Numbers 2290 BSI RF 28. I am not sure of the strength. 2) I need 12 1/2" non tilt Channel Balances that are 16" long, Part Number 15DS BSI RL 23. I am not sure of the strength. 3) I need 18 Tops ... I believ ... (cont.)

Hey guys looking for this part for my sliding patio door. No place I can find the manufacturer. Any help is greatly appreciated