Viewing all customer Discussions for:

81-272 1-1/2" dia Roller And Axle Kit

Need these 4 rollers

1" tall, width is 13/16", wheel is 1.5" and is concave

Hello, I've attached photos of both parts I'd like to replace. Do you sell these? Thanks!

Can you please identify the carriage and roller shown in the attached photo? I need two of them.

Hello, im looking for tandem duel in the door rollers. I pulled the old part out (first photo attached). Theres some aluminum fins attached to the top that are .5 inches long. I was able to remove the fins by carefully bending them out to put them on a new roller housing, so its not that important t ... (cont.)

I would like the whole part. I need 2 of them. If you only have the wheels I might be able to make them work.

caartridge: 3 1/8" long (not including wheels) cartridge: 11/16" width to outside cartridge: 1 1/16" high wheels: 1 1/2" diameter material: all metal - prefer premium stainless steel if you have em.

What replacement roller do you recommend for my ~25 year old sliding pation door? There are two sets of these rollers on my door.

hello, I am looking for some guidance in replacing my patio door wheels. They appear to be 1/2" diameter wheels, however I am unsure of the proper assembly to purchase. I have attached images with measurements. Any guidance is much appreciated.

These rollers are from Klein patio doors that are about 40 yrs old. The wheel width that fit in the track (outer to outer) is 11/32" as best I can tell and the entire roller is about 1-3/4" diameter. I have 6 of these doors and many rollers are worn. The have both steel and nylon rollers. The ny ... (cont.)

I can not find any markings on door or hardware. Door is approximately 50 yrs old. The roller on the latch (locking) side is a little different (larger one) than the other one. If there is anything else I can do let me know. thank you

1 1/2. With a 1/4 INCH BORE..I NEED

1 in wide 1 3/8 in tall 2 3/8 in long

I cannot find anything on the door or the rollers that indicate the manufacturer. I need to replace a pair of rollers for two bypassing doors (4 total). Any help would be appreciated...thanks!

This is the runner of an old sliding door that used to go to a patio and now goes to an extension room ok the house, so interior. There are to of them, single roller each. I've tried finding parts at all of the box stores, but nothing seems to be the right one. please help.

Measures 2" tall 2" long and 5/8" wide wheel is steel and approx 1-3/4"

I am looking for this roller for sliding door. I have attached pictures below. Please let me know if you need any further information. Thanks Lisa

Sales, I have an older closet mirrored by-pass doors. A set of rollers has gone bad and I am unable to find replacement rollers. I am not looking to replace the whole wheel assembly. I am reaching out to manufacturers since I have not found this particular size in retail stores. I’ve attach ... (cont.)

Need Help Identifying Replacement Roller - Roller has Stamp "DISCO 2192"

I'm needing help finding the part number for the rollers on my sliding glass door. Please see sticker on door below. Thank you! SGD-C20/SGD-C30. Series PA-9, ANSI/AAMA 101-88, MST 15080