Viewing all customer Discussions for:

87-203 Alenco Sliding Window Roller, 1/2" Flat Brass Wheel

No markings on window

No name on frame, 1 1/2 inch long, 3/4 inch wide and tall. Thank you.

LOOKING FOR REPLACEMENT PARTS FOR OUTSIDE FRAME PARTS PLASTIC APPROXIMATELY 1" THREE PER WINDOW AT BOTTOM OF ALUMINUM FRAME ALLOW FOR WATER TO DRAIN OUT OF WINDOW FRAME APPROXIMATELY 1/4" WIDE

We got these used Alenco windows and they are missing parts that keep them open. The only parts we see are these rollers. There are no parts on the opposite side of the windows. Can you help us figure out what we need? The series is: 3722/3722F . Name: A-161-1 . Spec: HS-R25. MST: 10050. ... (cont.)

I have a window track that is all messed up and the roller ball seems to be broke. I need a replacement before the snow starts. Can you give me a quote?

Milgard slider roller(s) needed to replace a lost roller and several damaged. Windows purchased and installed ~ 20 yrs ago. Dimensions L = ~1-3/16, W=5/8", D=3/8"

Anything like this available? Sliding windows part of a solarium added to house sometime in past - not sure what date, manufacturer, who installed, etc. All brass rollers have flat spots. Alternatively, the roller is brass 1/2 inch in diameter. Axle is 3/16 in diameter and 3/8 long. Replacing r ... (cont.)

Need help identifying this sash.

1 1/2" long, 13/16" wide, 1/2" tall plus small tab in middle to lock into window

Alenco window. Attached are photos of the roller and base frame of window that shows the installation of the roller. We purchased rollers. 87-203 thinking they would work. However, the tab prevents the roller from being inserted into the frame. What roller do you recommend?

Hi I'm sorry to be so vague, but the problem is that all the parts are missing from the window besides the locks. Causes window to fall forward out of track when not locked. Can you please tell me how many of each part I need to bring back to original condition?

Original aluminum windows - house built 1997 Phoenix, AZ area. Gold label inside window says: Series 3722/3722F Name: A-161-1 MST 10050 ANA/AAMA/101-93 NFRC/100-91 The windows say ALENCO but the Alenco co. said they are not really their window brand - that the builder just used that. D ... (cont.)

I have a couple of Alenco windows since 2000, the rollers is not good any more, like to buy the parts to replace them. I checked the size, should be 87-203.

I need to replace some window rollers but no brand name is on the windows. Only markings on metal dual pane windows are RAL 394 7717, which is on metal edging between the panes all around the window. Were installed in 1993, when house was built new. Photos atached John

Hi, I have an Alenco Window, it is marked RAL I-95 3/8 inside the frame. Do you have a replacement window roller for this? Could you please tell me the part number or link?

I need the sliding window roller shown in the picture. My windows are from the 1990's.