Viewing all customer Discussions for:

82-260 Multi-Point Mortise Lock with Pocket Plate, 12"

Broke, part number

Looking for the strike plate for this Pelli door lock? Jerry

Looking to replace this latch with an outside key lock and latch. Can you help?

I have 2 of the same doors, one has a handle on both sides but no handle with the locking mechanism, there appears to be the hardware in the door. (photo door 2) The other door the outside handle broke off but the lock works (photo door 1) If I can get replacement for the one with no locking mecha ... (cont.)

Hello, my name is Omar. I need to replace two locks and handles like the one in the picture. They don't use key. The door is 1 1/16 thick.

Sliding glass door double lock. No name on the door to identify the brand. Total part from top today bottom in 12 1/2".

Need this Muti-point mortise lock with face plate 12 in

I need an internal lock and locking mechanism, the one that slides up and down on the frame work on the left side of the handle. The keeper is fine as shown in photo. The keep dimensions of the keeper are: 9 3/4" in total. Screw hole to screw hole 8 11/16" . Width 11/16". Space between where lock go ... (cont.)

Locking lever broke-off of the sliding door latch and locking mechanism, seeking replacement. Length 12 1/2" X 1" Thick X Depth 1 1/2".

I need a replacement for a latch on a vinyl door, 12 inches center to center. The old lock consists of a cover plate and a mortise lock 1 1/16 inches deep (see photos). I ordered part number 82-239 because the screws on the mortise lock are on 9 7/8 inch centers, but it does not work. Which part do ... (cont.)

I have a Gorell 8/0 x 6/8 Armor Max Plus sliding glass patio door that was installed in 2009. The installation instructions, (attached), indicate 5301 as a model number. The lock assembly has been broken and needs to be replaced. I have attached photos. DO you have this part available? ... (cont.)

There are no names or model numbers anywhere on the part. Need 2 of these.

Unable to lock my sliding doors the flat shaft on the keyed cylinder is broken on 2 of my 3 doors, the slot that the shaft goes into on the knob side is also broken and the engaging pin on the other lockset does not spring forward the engage into the metal latch cleats on the jamb side. Dennis thank ... (cont.)

I am looking to replace the locking assembly on my jeld wen slider door. The

Would the 82-265 and 82-086 be the correct replacement hardware?

Hello - I need a new multipoint latch for a 15 year-old Marvin Wood clad patio door. There are two locking jaws and the mounting screws are 12" apart; the assembly is 1" wide and has a recessed face. What else do you ned to identify?

I have a broken part on a sliding door. This is a photo of the same piece but not broken. I don't know what it's called or where to find a replacement part. If you can help me I would be thankful.

I am looking for replacement Or substitute for imperial USA door handle for my patio door. The length between installation holes is 4 inches

Door Latch outside measurements 12.5 inches high , inch wide. Inside measurements 8.5 high 3.75 Inches wide The numbers written on the glass were 16CFR1201 II & SGCC1804 1/8 UA

Hello I need a replacement for this lock. Thanks in advance for your help.