Viewing all customer Discussions for:

10-325 30" Shower Sweep With Drip Rail

This is a framed glass door. Sweep and drip rail have separated from door. Cannot find screws for the attachment. Need suggestions to remove and re-install. See pictures IMG_1067.jpg IMG_1066.jpg

My framed door is 5/8 thick. Existing sweep is a slip on u channel one like those used for frameless doors. Do you have any suggestions for a replacement? Been looking all over to no avail.

Does the shower sweep come in 44 inch width? Thanks

There are no markings anywhere in shower to identify it. It's original probably mid 90s. I'm looking for a replacement for this drain rail. I don't think it ever had a plastic or rubber sweep.

Thanks for your help. Here are 2 photos of what I now have. John R

Shower profile is attached. Length is 29 inches and is on the bottom of a framed hinged door. Thanks

Hi, I have what looks like a "home made" shower door and need to find a way to prevent water from leaking over the threshold. Is you door sweep the right solution for my needs?

I just installed the 10-325 shower sweep with drip rail and noticed that on the left end (NOT the side closest to the actual shower but the side that actually swings out when the door is open) the metal could potentially be a hazard if one were to hit it hard. Do you suggest putting some kind ... (cont.)

I have a 1989 door and the rubber strip is falling apart. I can't find the strip so I assume I need to replace the whole sweep. I can't find anything like I have that wraps around the door. What do you suggest?

Hi - I need to replace a shower door sweep that slides into the bottom of a hinged shower door. It is a T top - the top of the T measures 1/4 inch across. It is 36 inched wide and 1 inch deep. Can you please help? Thanks

My 23 1/2 inch chrome shower door sweep needs replacing. The vinyl strip is loose. In your photo of sweep 10-325 and 326 the vinyl strip looks dark brown. Is that the case or do you have gray or clear also?

this rail measures 24 1/4" and has a notch on the end. Will the 24" shower with drip rail be the correct replacement?

. one is the plastic bushing that goes onthe hinge peg, black The other is the plastic for bottom sweep and side seal that goes into a T- slot/track in the door. Shower is LASCO 20 years old, but not sure what brand the door is.

I am looking for a replacement shower door sweep. This is on a keystone (KSD) model 55S-T300 door. 30"

Hi: looking for a replacement. Please help.

this shower is 29 years old .....the door across the bottom is 30 1/4 ' the part is 30" the holes ar on either side and in the middle.

What would you recommend? I need to replace, only has three screws in this sweep. Thanks.

What is the height of the 10-325

Hi I took apart the bottom of the shower to clean it and forgot to pay attention to where the grey piece goes when reattaching. Any chance you might know? I also would love a replacement part for the metal piece. The shower handle says Work Right but I don

The space between the bottom door frame and the shower frame is about 7/16"; when I mount your 10-325 how far below the shower frame should the sweep (10-327) be located? Want to make sure before I start drilling mounting holes. Thanks for your help! Mike