Viewing all customer Discussions for:

82-265 Multi-Point Mortise Lock with Face Plate, 11"

Hi there. Looking to replace this handle. Any help would be amazing.

Hi, I'm looking for a replacement lock for a ReliaBilt sliding door. Part is labeled as PM52x, as part of installation of a PD3000 handle kit. It's 9 and 3/4" center to center for the mounting holes, 9/16" wide and 1 and 1/16" deep.

The lock is broken

Full Replacement Lock & Hardware Parts For 3 Jeld Wen Sliding Patio Doors

We purchased a Jeld-Wen sliding patio door and found that it doesn't have the keeper for the locking mechanism on the door handle. What parts would we need to purchase to install for the door to lock properly? From what I'm seeing on the site, it just shows a keeper, but is there something under it ... (cont.)

Do not have original door handle. Would like a replacement suggestion. Need the handle, lock, and latch. I have been told that this is possibly a Superior Door brand.

Hi Hope you can help with the replacement for a PPG Herculite handle and lockset as per two pictures attached. The information on the door seems to relate to the glass rather than the door itself. Door is about 20 years old. Thanks so much!

I need a new handle with key access and a double lock for a Simonton sliding patio door. Where or who can I buy that from?

Need to replace a Track dual Mortis lock. Screws are 11" on center. Part # is 5820.170

Do I need to replace the mortise when installing the Product Code: 82-086?

Their is an up and lower hook that flip out and clamp the strike plate. The top flips down and the bottom flips up.

I purchased your latch Item # 82-239 as almost all the measurements seem to match, however the keeper plate has a 12" span and does not screw to your latch. Please help, I really need to find a replacement!

Sliding glass doors were purchased in 2005 from Win-Dor windows. These are the measurements as accurate as possible: entire plate is 30mm, top & bottom screw holes are 11" apart, the 2 screw holes in the center are 4" apart and the lock holes are 8" apart.

Hello - I have a Atrium sliding patio door with a PD3000 handle. The part number that broke is a PM520A - see attached pictures. I believe it is a Mortise multi-point locking system which has a separate face plate... Looking at your web site, I have identified part number 82-265 - multi-point l ... (cont.)

The attached pictures of what my current hardware is. I ordered 82-239 which does not work. I was hoping maybe the pictures would allow someone on your team to identify the correct part number. I believe this is from an Andersen Silver Line slider. There are no markings or stickers on the door to ac ... (cont.)

Need to replace the locking mechanism of a TRACO 6080 sliding patio door. Handle screws are 315/16th inches apart ( center ). thx's Bill

The locking mechanism inside our guardian door broke. I haven't been able to locate a replacement that will fit in the slot on our door. I've looked all over for something that will work, but haven't had any luck.

Hello! I am having an issue with my lock and tried to take it apart (perhaps my first mistake! lol) thinking I could fix it but have realized its beyond my ability to repair. I've attached some pictures and just wanted to ensure I pick the correct lock to replace it with. Perhaps also if there is a ... (cont.)

Good day, i purchased a home and I do not have a key for the patio door, my only access to to rear of the house. Dimensions are 11 and 3/4 overall length. 11 inches center to center of screws and 3/4 inch wide. Hopefully you can help me. thanks Christian

Hello, I am looking for a replacement part for my sliding glass door. The latching mechanism broke. I tried other latches however having trouble finding an 11 3/4" faceplate.