Viewing all customer Discussions for:

81-279 Patio Roller Assembly, 1-1/4" Steel Ball Bearing

Need help fishing replacement rollers can you help?

I have been trying to locate replacement rollers for my sliding glass door. I can not find anything that resemble the original rollers. The roller pictured is from my sliding glass patio door, there are two of these, the roller pictured appears to have all the little rollers in it, the other roller ... (cont.)

Several days ago we called about roller replacements. Here are the photos of the rollers.The first photo shows the lower frame which supports the glass and holds the rollers with a screw securing the roller assembly to the frame.The second photo shows the approximate dimensions of the roller assembl ... (cont.)

We measured and the measurements we got were Length - 3 1/4 Width - 5/8 Tall - 1 3/4

These rollers came off of sliding patio doors in a condo in North Myrtle Beach, doors in which lead to a balcony on a second floor that gets riddled with wind, salt water, sand, moisture, improper care, etc. A few of the other rollers crumbled as we removed them, as did the bottom of the sliding p ... (cont.)

I need a replacement part for the bottom roller of a GLW patio door. Please see attached pictures. If this part is not available, is there any part that could be substituted for it? Thank you in advance for your help regarding this matter.

This door was purchased from Mr Window in Carmel, IN. They had requested the part from Ply Gem directly. When received, the part on the bottom of the picture is what was received. According to the installer, the part was too wide and could not be used to replace the part. The picture above is fr ... (cont.)

2.25 inches long 1/2 inch wide Wheel diameter 1.25 inches

Outer stamped metal is 1 3/4" tall, 1 15/16" long, notch at bottom is 1/16". Inner stamped metal is 1 11/16" tall, 2 1/16" long. Outer bracket is 3/4" wide before it slims down to squeeze inner bracket. Inner bracket is 1/2" wide. Wheel is 1 1/4" diameter.

Hello, My sliding glass door uses the old tank track style of roller. Instead of a wheel, it uses small plastic cylindrical rollers that roll around in a groove to allow the door to slide. The assembly is 3 inches long. I would like to purchase a suitable wheel assembly to replace this older style ... (cont.)

I'm looking for a replacement for this patio door roller.

Looking for new rollers for above door.

L=2 1/2 W=3/4 H=1 3/8 Wheel diameter=1 1\4

I am trying to find replacement rollers for my sliding glass door. Here is some info from labels on the door. ?Label on side of panel (note SGD = Sliding Glass Door) ?Series M-800/M-825/M-850 ?SGD-R20 ?MST-12069 (00X) ?Manufacturer Stipulates Conformity to ?ANSI/AAMA 101-85 ?M

I need an entire roller for a sliding glass good. It's an older door and am not able to find parts locally . I need two in order to balance the sliding glass door

There are no markings on the hardware the only marking I can find on the door is PPG, which may be only for the glass

This door has no manufacturer that I can identify. The sliding mechanism has roller bearings. Size: 3.1/4" x 1.5" x 5/8"

Hello, please help us identify this roller and if you have it available for sale

The pictures attached is all I have, no numbers or identifying marks.The drawings pictures are from an older catalogue from Amsco which is the correct part.Carl

Roller for Swisco 5GD-R25 2 1/2" long, including tab 1 1/2" high, including roller sticking out 1/2" wide Doesn't match those posted on your Web site. Thanks for your help.