Viewing all customer Discussions for:

S395-35 35" Series 395 Channel Balance

Kinco made window, need channel balances for two windows. One is marked "29-6 KX CMC 7". The other has no marking on t, and is 35 inches long. End hardware is the same for both sets of channel balances.

I purchased four channel balances (two windows) from you about four years ago. I now need another set to replace for a different set of windows. This one has the marking (photo also attached):34-4 IX CMC 7 I removed the broken balance (plastic on the top part was shattered and is shown in the pictur ... (cont.)

Hi, For years, I've wondered whether I would ever be able to find replacement parts for my failing Viking window channel balances. I discovered your site, and have been very pleased with the results. Quick shipping of a quality product. The 29" 395s I ordered worked out perfectly, the window in que ... (cont.)

I Need 8 of the 28 3 and 4 of the 34 4

Need help please. I need to replace 4 x 35" Balances for single hung windows, the sash weighing 23lbs. The channels are approx. 5/8" wide and 5/8" deep, (although this could be slightly different as my tape measure only goes to 1/8ths). The writing on the Balance says: 34-4 LX CMC 7 The pla ... (cont.)

I need the part number for the channel balances I just removed. The numbers on the balances are 34 4 IS Caldwell. The sides are hemmed. I've attached several photo's.

Need parts for both sides of window and top caps. Can you give me part numbers and prices. I have 4-5 more windows to do after I try it on this window.

Does the stamping "34 3 DQ Caldwell" help in cross referencing the right part for my window? I need 2 balance rails.

Hello. We are trying to find balance rod replacements for several of our windows. The one in the photo is stamped with 2919, we need about 20 of these including the plastic sash cams. Do you have parts available? Some of the others we need are stamped with 3428. I believe we need 10 of these along ... (cont.)

I need replace part

I am trying to identify and purchase the replacement parts for the Atrium Window Non-Tilt Block and Tackle Channel balance the code on the existing is: 34-5 EA2 CMC 12

I need to replace a channel balance for an atrium window 35" long, 26.5 lbs. could you please make a suggestion from my photos. None of the channel balances seem to duplicate the old one. Thank you.

I was given these part numbers.. FA2830 and FA3540. Hope this helps. One measures 29 inches and the other 35 inches. 1/2 Width.. Non-tilt window Arturo

I need help finding the correct or similar balances that will work for my window. the stamp on the 35" balance is 34 9 KW CMC 7

Channel length is 35" bottom looks like 15-001 top looks like 19-005 and 1/2 inch width. Not sure what the weight rating is can you tell by the stamp

Looking to purchase two channel balance. The stamp numbers 34 4 IU CMC 2. The lenght is 35 inches. The two photos show the end pieces of the channel balance unsure which model to order. Would also like to order two clips. Please me email me the correct part numbers for the channel balance and clips. ... (cont.)

I have attached photos of the channel balance guide I need to replace. It is for a non-tilting window, 1/2 inch wide and 35 inches long (metal track only not including the plastic clips on each end). It looks like the top clip is a #19-005, but I'm not sure the bottom clip matches any on your si ... (cont.)

If you would like, post pictures of your current balance and we will take a look to see if the S350 balance is a good match. Include close up pictures of your balance bottom and top.