Viewing all customer Discussions for:

58-189 36" High Performance Door Bottom

It looks like your 58-173 weatherstrip can replace my old Loewen push in weatherstrip, however, my doors are 92 inches in height. Is is possible to get your weatherstrip in 92 rather than 82 inch lengths?

I have a 10 yr old Steelmaster Entry Door System #949-HM (Steel on the outside & wood on the inside). The door measures 36" X 78". The company has since gone out of business. I need a new door sweep as the rubber on the current one is separating into what looks like 3 rubber strips or pieces and ... (cont.)

I need to replace the weather stripping on the bottom of my pella door but it looks like there are screws there and the weather stripping does not slide in and out.

Looking to replace door sweep on Pella entry doors, 36" & 34." The same sweep fits each door. I have attached pictures below.

Hello, we are looking for replacement sweeps for our Benchmark double door steel front doors. The doors are 32 inches by 1 and 3/4 inches. The sweep is 31 and 3/4 inches long by 1 and 3/4 inches wide. I

It has 2 screws on either end, I removed the screws but was unable to get the seal out. I didn't force it to hard in fear I would reck something. Wasn't sure if this was the seal or if a seal fits into this.

How would install a door sweep Part# 58-189 ? Slide it in from The end of the door or align strip along Bottom of door and push it straight In?

Hi I have 4 doors that need to have the bottom seal replaced but am unable to find the right seal in any of our local building supply or hardware stores. I have taken measurements and pictures of the part. they look like the part #58-189 but is only a bit over 3/4 inch wide (front to back) and only ... (cont.)

the door is a part # 400clm it's a wood core steel door. this is a picture of the bottom sweep it's 1 3/4" wide the closed sweep is the inside part of the weather strip this is a stick on sweep there is no track on the bottom of the door that is slides in to. it's a 36" door. Please help winter is ... (cont.)

I need to replace the door sweeps on a double Stanley door. The kerfs are 7/8" on center, so I think this 58-189 sweep is the best for me. My problem is that the threshold (metal) bows upward in the middle so the gap on the hinge side of the door(s) is 3/8" and the gap at the lock side of the door(s ... (cont.)

My customer requires a replacement entry door bottom seal. I attempted to use 58-189 but it would not work. The center tabs on the bad seal two attaching tabs are spread apart slightly more than on 58-189 and they are a little higher and they had an angled edge on the outside top that hooked on the ... (cont.)

all my doors are steel. there are NO labels on any doors. i assume they were purchased at lowes or HD, as there aren't many options where i live. i don't believe the 58-189 would fit. Any thoughts? also, i purchased a sweep (58-176) that i thought might work, but must return it, as it wasn't clo ... (cont.)

Door is 36X 1 3/4. Space between the attaching guides is roughly 7/8"