Viewing all customer Discussions for:

26-324 Thumb Button

Looking for parts picture attached

Hello, Do you have a part that will replace this tilt latch? It is an internal latch. The piece is 1 5/16 long, has an offset pin that fits down into the hole into the spring mechanism. The piece that hangs down is a smidge over 1/2 inches from the left. The pin is on the back side ... (cont.)

Your part 26-234 in the foreground has the proper clip width and thickness but the depth isn't sufficient. My clip (in the background) is similar the the Pittsburgh guy's. It has much longer prongs and two offset raised guides.

I am looking for some of these internal tilt latch operators for one our customers.. Daryl with South Seneca Vinyl

Original white vinyl ~1996 windows. Have a few internal tilt latch mechanisms broken and need to replace them and associated thumb operators. Need to find equivalent parts.

Broken window release for drop down vinyl window

These internal tilt latches are 4 1/2"x1/2"x5/16". There are no markings on these vinyl windows anywhere. I believe they were installed in 1996/97.

We have a home full of Traco windows and several have broken or missing tabs - see pictures. Can you help in finding replacement tabs? Ross Ford

hi , Iam looking for a tilt latch

A few months back I saw an internal tilt window latch (LH) with your part number 26-221. It's dimensions exactly matched some latches that I need to replace. I also need some RH latches. When to order the parts of this design were no longer available. Is there a latch that will work in place of 26-2 ... (cont.)

I need the "J " facing me when holding it lengthwise

The balancers are 16 and a half inches long i need 2 left and 2 rights i also need the top and bottom latches or pins im not sure of the official name the window has no name on it the balancers are 16 and a half inches long i need 2 left and 2 rights this is fir 2 windows they are the same ..i need ... (cont.)

Good Morning, I have vinyl panels in my lanai. My house was built in 1999 and the plastic latches for my panels are snapping off now due to time and weather. I've attached a copy of the latch. The latch pulls back to allow a "peg" at the end of the window to engage into the slot the panel goes into. ... (cont.)

Part is 2" long and has grooves to slide to the left to tile window. Mfg by Barrier Ent . Thank you for your assistance

Hey gang, Looking for this tilt latch button. Thanks, Erik

Looking to replace this broken thumb latch piece. Dimensions are 5/8? wide x 1 7/16? long Vinyl replacement Windows came from Window factory in 2001 if that helpsAlso would like to directions if any for this thumb latch Would like to know how the tilt latch goes together with the thumb latch if po ... (cont.)

Please see attached images of the parts I need. I believe one is called tilt-latch (in pair) and other one is balance tilt. Tilt-latch measurements is in the picture.....balance tilt is about ~1.9 x 0.8. Please send me the URLs of the compatible parts. Thanks, muhammad