Viewing all customer Discussions for:

36-022HD 12" Four Bar Hinge, 45 Degree, Heavy Duty

Broken hinge. This side isn't broken, but the left side one is. Window is 21 years old.

I was recommended/ordered part 36-022HD but it was not the correct fit.

The slide bars on my 30 year old Kinco casement windows have broken. They are 12 inches long with the arm being 8.75 inches. What ha broken is the black plastic piece on the slide

I have tilt out windows that have a locking arm that supports the window when opened out.

I need to ID these parts on an old vinyl window Rt and lft flanking casements top and bottom hinges, sash track and operators. Thank you, Peter

I need to ID these parts on an old vinyl window Rt and lft flanking casements top and bottom hinges, sash track and operators. Thank you, Peter

I believe you have mentioned part number 36-045 in one of your posts to match the casement hinge as shown. Is that correct? If so, how can I order a pair?There are also other Truth Hardware very similar but slightly different, such as both arms meeting at the same pivot instead of being attached to ... (cont.)

The black plastic part in the bottom is broke...

I have 3 long vertical Acorn windows that crank out from the bottom. When I went to open them yesterday the top part of the window detached and had to be pushed back in from the outside. The black plastic part is cracked so there is nothing to hold the top of the window in place. Do you have the rep ... (cont.)

On the casement window, we are looking for the hardware located on the bottom as viewed from the exterior hinge right. Our piece is broken and the window will not close properly. The crank mechanism is fine.

Trying to find replacement part for frozen/rusted casement window top hinge

Looking out window. Its the right side top hinge. NAMI NFRC 100/200 CODE HII-1 RATING NFRC SERIES CLCASE MST 2650 NFRC HII-1-006-7/ 14-15 97-M

I'm looking for replacement part on the right upper side of the window. The hinge as seen in the photo D3686669 the black piece that holds the sliding arm together snapped in the middle. I'm also including a picture of the right upper side hatch which is intact.. can you help

I contacted Comfortline and was sent a replacement part with arms in a different location, so the sash would most likely need modifying. They said they have no other options on their end... just wanted to see what (if anything) you had to offer before I start modifying the sashes to make these work. ... (cont.)

This is on an aluminum framed tip in window in an old school but I have not been able to find this part

I think I need the "L" shaped part. When I close the window(turning the operator counter-clock wise), it does not close completely. Something is stuck at the end of the closing cycle, so the window does not close tightly. The window is still open about 2 inches. That is all I can do when I close th ... (cont.)

numbers are 40293 on base, 30564 on tip and 30559 on arm base 12', arm 8 3/4" profile looks to be 1/2

Good afternoon. Do you have installation video of 36-022HD hinge? Thanks

Hello I have NFRC 100 Series windows installed around my house. I have been having challenges with the hinges breaking off mainly because the connectors are made of plastic. I guess due to wear and tear this is common. As a result of this, the windows when opened do not tend to stay intact; they lea ... (cont.)

From inside the home this broken hinge is upper right. Need replacement part.