Viewing all customer Discussions for:

82-089 Legacy Handle Set, 3-15/16" (1-1/8" to 2-1/2")

I need a replacement door handle for my sliding door. The top metal bolt holder broke off the handle. Color is ivory, and distance between bolts is 4 inches, and distance from bottom bolt to the locking pin is 1.5 inches.

Hi, I'm looking for the lock set for my patio sliding door with two latch lever. Its color is Not white. Please let me know if you have it in stock. Thanks Freddy

Looking for my back sliding door handle

We would like to add keyed lock what do we need to buy? Can we just add lock or do we need to buy complete handle. Thank You Otmer Evans

The handle on the right is clearly not a correct replacement, but I believe I need to replace both sides handles and the mortise lock. I am not sure of the part numbers needed to make this start working again.

It states amesbury hardware on the back and the inside handle has "B" labeled on the inside and the outside has an "A" on it.. It's also a keyless lock and the top to bottom screw holes are 4' apart with the lock hole an 1 1/4 from the bottom hole..

I am looking for help identifying the handle/lock for our sliding glass door. I have attached 3 photos. Thank you.

The handle is dark brown. The overall length is 10". The mounting screw spacing is approximately 4". There are two molded markings on the under side of the handle. One is "Sash Controls Canton, SD". The other is "Patent D466787"

Need help identifying what door handle this is.

....but have no idea of the parts I have currently, as there are no markings, names or branding. I'd like to replace what I have with the more modern handle above. Is that possible? Would you even be able to tell from these photos?

Good day, I am trying to locate replacement handles for my slider doors. The locks are in good condition, but the exterior handles are falling apart from salt air exposure. Can you help?

PAT #:6.264.252 is written on one end and PAT#:5.820.170 is written on the same side but opposite end We have not been able to find anyone to help replace our door handle, only a local handyman that was able to unlock it and remove it for us. Everyone says they do not work on these locks. ... (cont.)

Hello, I need to replace the sliding door handle and lock set. The patent # I have is 6.264.252. Below are the pictures of the multi point mortise lock and door handles. Could you please suggest the best compatible parts? Thank you

Good day/night, Hello everybody, I'm trying to find the latch or handle assembly to replace the broken one I have please. Thank you kindly

Looking for the attached handles and the pair with the latch. White is preferred but will consider satin if white is not available.

We are in need of a white Jeld-Wen handle set and mortise with thumb latch. The handle holes are 3-15/16" apart. The casement lock parts may or may not be Jeld-Wen but most importantly I need the broken pc that slides up and down and connects to a bar perhaps, that actually locks the window. I need ... (cont.)

Need inside and outside handles keys and screws

I am needing Pella replacement patio door handle from 2007. The product I believe will work is 82-089 . However my handle is installed on the reverse (see picture) Will this work for me? The measurements shown are correct for my door otherwise. Thanks!

I have a door manufacturered in Aug of 2016 that has failed. I need to replace the locking mechanism and the door handles. Can you please advise me own what I need. I have more pictures if you need them.

I have a client that has aluminum slider with no proper handle and lock. The house was built in 1973. someone Jerry rigged a handle on that inside- so you can ignore that. Attached are photos.the slider is 1-1/8" thick. the slot for lock is about 1/2" wide.the face of the aluminum slider frame is a ... (cont.)