Viewing all customer Discussions for:

S161-10 10 lbs Series 161 Roller-Tilt

Can I get the part number for the replacement for these

Im looking for this part

MGG 12/2021 ORD . 191366791.4

Hello, The coil spring for our vinyl window is broken and the window keeps falling down. MI Windows Series: 3540, CODE MIL-12, Perf Grade LC-PG35*, +DP 50.1, Water 5.43, Max Test Size 36.00 X 74.00, MFG: 11/2021, ORD: 191379452.5. If you have a replacement for this, this is the RIGHT one, but we'll ... (cont.)

10 L 10R

I need the right balance springs I would need the part number

1/2 inch thick coil tape

I have a double hung window (I do not know the brand) where the lower half has broken coils or springs. It is the part that helps lift the window. From what I have found searching, it is called a constant force balance. I was able to remove the window, and I can get to the broken part (and I thin ... (cont.)

Hello I need the S161 roller kit. How do you remove the old and install the new thank you

Need to get 2 of these balances. If there is a comparable one that doesn't have the clip style, if not no worries

Please see photos attached and the coil spring broke and need the whole part replaced. It says 10 L on the part. Thank you

Need 4 of these.

We are installing used windows and noticed one of the windows is missing the piece above.

I think I need 2 different QuickTilt Coil Spring Window Balance units. The last photo shows the piece that broke out when my wife was cleaning the tilt window. They are both on the left side and the ones on the right side function properly. Measurements 2.58" tall 1.35" wide and .57" thick. ... (cont.)

I am looking for a set (L & R) window counter balance springs and feet for a window. Foot measures: 2 1/4" x 1 3/16" x 1/2" and is stamped with a "10" Devices has an external spring that sould have connected to the interior one but the end is broken off. The clear mounting plate measures: 1 1/4" ... (cont.)

I need to remove the part that is pictured. It stops my window from closing completely. It has the number "10" on it. Assistance would be greatly appreciated.

Unfortunately there is no branding badge on any of the windows. Only window in the house with a coil balance and both coils are broken so I don't have pictures of a full proper installation. I am unclear if the entire coil is supposed to sit inside the shoe housing or not. Shoe body is 2 5/8" tall, ... (cont.)

Need three replacements of this part because the bottom part of the piece (where the window is supposed to be held) is cracked.

I would like to know where to buy replacement parts for my window.

Looking for a replacement "u" bushing or pivoting "u" nut for the pivot lock shoe shown in attached picture. If part is not available, okay with purchasing replacement pivot lock shoe mechanism for a coil tensioner similar to that shown in picture. Pivot lock shoe is 1 1/4" wide x 9/16" thick x 2 ... (cont.)