Viewing all customer Discussions for:

39-001 Window Crank Operator, 9"

We are using casement windows that came out of a warehouse years ago. Bought them from a architectural salvage company in Dallas. Let me know if you have replacement parts. I can also send pictures of the windows themselves if needed. Thanks! I'm not the one doing the work. Have a couple of guys do ... (cont.)

ok

We are looking for replacement cranks for these 1943 metal casement windows. Thank you. Leslie

I have included 3 photos. Please tell me what the correct pieces are.

I measured the single arm from screw hole to tip at 8 and 3/4 inches, exterior measures 5 and 1/4 inches, exterior holes are 4 and 3/4 and interior holes are 3 and 7/8 inches. I thought maybe your part # 39-001 might work. Thank you for your help.

Good Afternoon, Attached are pictures of some old steel windows in the Cottage building at the River Hills project. Do you know what window openers, locks, etc might work for these windows? Please let me know. Thanks!

Please help me identify this casement opener. thanks, mike

To Whom It May Concern:I have 16 properties that have these types of operators and I need to make them operational. NOt all properties are the same but we can begin here.Typical operators throughout house in bad condition. If you can identify this part I will send you quantities of left and right.Ca ... (cont.)

Hello, Can you please help me identify a replacement for hardware shown in photo attached? I believe the stamp says 1.H. I.R. The arm length is 9 inches and the bolt holes are 4" on center.

I just bought an older house and all windows have this kind of opener. None of them work. Do you have this or a replacement that could fit? Thank you

Right and left hand window crank

I had originally ordered 39-001 and 39-002, but the arm angle is not correct as a replacement. These are 9" crank operators. Any assist would be appreciated. I need both left and right hand versions. Thanks, Marty

I am helping do some repairs at a non profit transitional living facility for homeless families. This facility used to be an old hotel. There are several window operators and latches that do not work. Attached are pictures of the a right side operator and a right side latch (both side latches may be ... (cont.)

I haven't seen a casement lock yet here with these dimension. Mounting screws 2 5/8" Gap between mount and lock point is 1/2" to 5/8" depending on where you measure it on the taper. Cranks 39-002 and 39-001 fit these windows perfectly, but I suspect that's rather standard?

Glass window operator

No markings aside from a "4" on the the back of the crank. Came from a 1920s era house. Mounts directly to the casement window frame, not the wood sill. Thank you!

I think my operator is more than 50 years old. It's about 9" from the end of the arm to the axle on the rotator.

does window crank come with the handle ????

my client old windows needs new hardware

To whom it may concern: I have casement windows dating back to 1952 and the operators are in need of replacement. I cannot find anything on the hardware that indicates the name of the manufacturer. The only visible markings are on the underside of each device. Those markings are as follows: 1. ... (cont.)