Viewing all customer Discussions for:

39-014 Casement Window Operator, 13-1/2" Arm

Hi, I'm looking to replace this part. It does not open the window without a little push with the hand. It will open and close partially after manually pushed. Thanks.

Casement windows installed in 1987 - still original hardware - TRUTH Issue: The operator arm that goes to the track on the window falls out of the track...the wheel bearing plastic exterior looks worn, and the arm does not seem to have any tension to keep the arm in the track. The track on the wi ... (cont.)

Broken casement mechanism. These are somewhat old. Need replacements

This hardware is cracked. I cannot find a replacement

Crest o pane windows installed in 1977. Windows are foggy, cranks are not smooth and locks are tough to close. Would like to know the replacement parts for all of these. There are windows that open the other way so cranks are opposite.

I need help with finding the replacement part

Hi, can you help me identify these window operator. I need two right open and one left. Thanks for the help.

Curious what is the model/part number of this and if it's still made?

I would like to order replacement windows crankcase for both left and right windows, the uploaded pictures are for the broken left window handle, the manufacturer is Truth and the no located on the undersurface is 45251 the case is 4" L, 1 1/2" D and 5/8" thick. The long handle is 11 3/4" from the ... (cont.)

I need one replacement hardware for my windows. They are marked Truth 45034-Lh. it has about 13" long arm. They have a straight bar with a roller on the end instead of the hinged ones. Do you have a comparable part?

I am looking for 2 right hand closers and 2 left hand closers. Craftline is the manufacturer

I'm looking for these parts for the top and bottom of the window. Part numbers I can see are 33177b and 30744. Not sure what brand window is.

They are all the same and the only one I can find with a part number is 45251. I don't know if this is left or right. I will need to order both. What is the part number for the companion (L or R)45251? Thank you!

I need to replace an operator. It would be the opposite side of the one shown. I am not sure the length of arm I need. ThanksJoe

I have a window operator, arm & crank handle, a right hand and a left hand that I need to replace. The spindle part is 4 inches wide at the top and the arm 13-1/2 inches if I measured correctly. The model # appears to be on the one RH 45358. See picture. Is there a replacement for this please? ... (cont.)

HI, hoping you can tell me what part/s to order.. the handle just goes round.. it doesn't catch correctly to open and close.

Hello I posted four pics. The first One is from a thread that someone else asked I have the same issue and my operator looks the same. From reviewing remarks I think the 39-014 will work in its place along with the gasket 39-564. The arm on my operator measures 13 1/2 " from center of gear to nyl ... (cont.)

The short piece is 6 inches and the number on it is 30350 and is on both the bottom and top of window The long piece is angled as it goes into the crank area but the part that extends out is 11 inches The wide piece with the channel is attached to the bottom of the window and is 11 inches long. Part ... (cont.)

Looking for a replacement window crank. Looks like a 13 1/2" single arm. The short arm has 6007 stamped. It is a wright mechanism. Cover is 4" long. I could only find ones that are 3 3/4 or 5" I'd like to see if they them with a folding arm. Most of them the long arm gets stuck going over the p ... (cont.)

I am looking for a replacement worm gear for the casement window cranking assembly. No markings are visible.Thank you,Jim