Viewing all customer Discussions for:

Door & Window

Hi, I'm trying to find a match for this casement window handle. The size is 4-1/4" x 15-16"

Length is 27 incches. No stamp found. Manufacture? Original with house...built in 1991. 2 balances.

I'm looking to add a locking cyl to a patio door as shown. Tailpiece must be centered in cyl and be flat. I am a locksmith working for a customer

Need help finding this

House was built approximately 1985.....the handle is 9" long with 5-1/2" centers. The small tube projecting from screw hole is missing so it won't go back together.

Please help. Need right and left

24" 2320 & 2330 Looks like Left and Rigth Other one is 17" No marks or code End and hooks looks the same. I will need both reference (Left and Right) on 24" & 17"

Hi there. I'm hoping you can help identify a pivot balance shoe I need. The windows are double hung Silver Line between 15-20 years old. The shoe broke free from the spring-loaded counterbalance. Attached are two photos of the broken piece. The number on the shoe is PAT 0467490 and PAT 4610108. ... (cont.)

Hi the latch on my door handle will not work anymore. I took all parts off, so I assume I need an entire handle and assembly but I don't know what existing handle will fit the same holes already in the door. Can you recommend what I need to purchase?

I need to replace the operator on a couple awning windows. The photos show the operator installed. Each section of the crank arms are approximately 9" long. The windows were purchased through Sears about 37 years ago. In looking at your awning window hardware on your website I found PN 39-0837. ... (cont.)

Looking for a part number for the pictured pivot shoe for a spiral balance tilt aluminum double hung window. It appears to be 3/8" thick, and just under 7/8" wide. I cannot get it out. One picture shows it by a cut-out, but I have not been able to get them out. Do you have a replacement part, an ... (cont.)

I am looking for new interior glazing stops. I need to reglaze an upper IG on a simonton vinyl single hung. When trying to remove the glass stops, the pc broke. I would like to replace all 4 sides thinking that the other 3 will probably break also. I need 14 feet total. Thanks, Bret ... (cont.)

I'm tring to find the correct part to fit a sliding door from around 1979. Our home was built in 1979 and the door(s) are original to the home. The only sticker I can find on the doors says, "General Aluminum Products, Charlotte, NC," and "Care Free Products." I would like replace the rollers i ... (cont.)

This is a counterbalance for a mastic window, the length is 36 inches. The shoe comes to a point on the bottom side. it is an 1"-5/16on each side and in the middle It's an 1"3/8 long. It's an 1"1/4 wide and a 1/2" thick

Which channel balance do I need to order to replace the broken one? The marking on it is 24 4 CN CALDWELL

HI

Looking to find availability and price for 16 sash balances. These are for Jeld-Wen single hung windows, side load, about 14 years old. The number on the side of the balances22-3 IE5 CMC 45. Gary

This is a right hand piece that holds the window in the groove when you open to clean the window. Well it holds it to slide up and down. The company just went out of business

Ideally, looking for a replacement threaded worm gear or complete assembly if available...see attached photos.

hello I'm trying to find replacement vinyl glazing strips for these milgard windows that were probably installed in the 80s. any help would be appreciated... thanks this is my best guess as to the shape and measurements of the strip I'm looking for