Viewing all customer Discussions for:

Door & Window

windows about 25 years old. I have ordered 24 inch red tip tention rods that are on BO. But also need the pivit block

Stamp has a 13 with a space and a 2 B.S.I. AND A PV MARKING. ALSO SHOWN IN PICTURE. BOTTOM HAS A ROLL ATTACHED.

We have an older aluminum storm door on our rental property. The small plastic pins in the top rail that keep the window in the frame broke. I am having trouble identifying the name of the piece or where I can buy replacements. Any help would be appreciated

Alenco no tilt balance 15D and 21C - please provide link to order replacement.

Window casing crank

Good afternoon,The 83-128 door latch I ordered is too small. It does not fit into the space. I ordered the door around Feb of 24. I will be returning this handle set and hopefully ordering the correct set if you have it.Thank you,Kris

Hi, I need help to identify the type of roller that is used. Thanks

Similar to your part 18-036 Same measurements as 18-036 but black in color and with attachment screw hole

29 inches 29 4 NN BSI

These are pics of a pivot bar that I need for an Alliance window. It looks like a pivot bar 26-316 but not sure. I also need 7 or 8 "shoes" for the windows. How do I know what part number they are? Windows are probably from 2003-2004. Bought the place in 2005. Thank you!

This is a new window about 4-5 years old. Vinyl. I do not see any markings on it.

I need help locating a part. It is for a Louisiana Pacific window I believe.

Just had a new roof installed on my mobile home. Apparently, the Amish roofers slide the old shingles down the vinyl siding and windows instead of tossing them clear of the mobile home. I've cleaned the tar from the siding. Now I'm looking to replace the damaged vinyl window beads. Can you identify ... (cont.)

These are channel balances I need to replace. They are stamped 27-10 (therefore 28" long) but have a pivot shoe I have never seen before. The channel it fits in appx. 1" wide. The piece on the sash is a (half round??) piece of plastic, again something I have never seen before. There is a rectangular ... (cont.)

hello, i need to replace the shown window crank

Hi, Trying to find replacement pieces for a 1968 bay/bow window. 4 panels- left and right windows open and the two interior windows are stationary. The locks are broken on one of the casement windows. It appears the name on the crank hardware is Etlima? I cannot remove the hardware due to safety i ... (cont.)

Here are some pictures of a lift where the string inside has broken. The metal measurement is 28". The stamp on it shows 27. I don't know what the brand is. Can you help me figure out what part I need ? Thanks. Glenn

Not sure what model and weight I need to be able to replace the balance both sides have broken.

If I pull the window to get a photo of the lower piece, it will take me forever to get it back in. I hope the upper piece will tell the story. I do not know the maker of these windows. The numbers on the upper piece are (as best as I can determine): on right- 5.365.638 on left- 5.232.208 (not su ... (cont.)

Has number 20810 on short arm and Entry Guard TRUTH on long arm. Also has 40471 on the base part