Viewing all customer Discussions for:

Door & Window

Can you tell me if you have the parts shown in the attached photos

Where can I obtain a replacement crank?

Need to replace this window balance. It has a white tip and measures 25 inches long, 3/8 inches wide

Looking to replace this model please

I am missing one of these supports. The support is 1 & 7/8" till 1 & 1/4 "wide at widest part amd the main part of the support is a little less and the support also has a rib facing the inside of the window

hello. I need help with replacement door lock and rollers for this door. I could not find any make or model info.

We have been trying to get a few of these operators replaced for years, and thought we had found the correct one, but there are significant differences, so VPI referred me to you. I have included a picture of that new operator also, so you can see there are no holes in the vertical surface. I do n ... (cont.)

Want to b sure I order the correct one.

i am looking for a thumb button that measures 11/2" length, 20/32 " wide and the measure between the post 1/4".

I need to replace all 4 (upper and lower) balance assemblies for this Simonton window. I hope the sticker gives you the info you need to find these parts

Looking for correct part to replace disintegrated triple coil balance. Windows installed 2005. Info attached.

Dear SWISCO,The balance system of two of my windows had Brocken. I took them out. On the spring it says 406L and it is a double springs system. Will you please tell me what the coil balance assembly I should get and where to get them. Should I also the pivot bars.Thanks very much. Your videos a ... (cont.)

I'm having trouble finding these.

I have Jeld-wen sliding patio doors, installed in 2011. They no longer have parts for these doors and I need new rollers. The door serial number is 00310620155163. They told me the part number for the rollers is 731400. I don't have a picture, rather inconvenient to take those big doors down and ... (cont.)

PAT #:6.264.252 is written on one end and PAT#:5.820.170 is written on the same side but opposite end We have not been able to find anyone to help replace our door handle, only a local handyman that was able to unlock it and remove it for us. Everyone says they do not work on these locks. ... (cont.)

I need replacement window balances with a stamped 32E BSI on them. The window is about 35 pounds. The length of the channel is 33 inches Picture 1 is the stamping and picture 2 is the ends. The channel is attached via the hook into a square slot.

This is the broken top bracket for a entrygard 20755 window 34.5 x 38.5. Here is the photo. Is this part available?

Hi,I'm looking for confirmation and availability for the block and tackle window balances which I think are your S395 balances. Based on the stamping number on the attached photo I need the following:1 pair of B15305 pair of B27303 pair of B3330 Can you please confirm this is the right product and ... (cont.)

The metal piece that slides into the balance is broken.

Hello, I have a customer looking to repair 20yr old wood bronze double hung windows that no longer open/close. The balancers are obviously no good. There is a sticker on the sill that say NFRC BWD K 002. The sashes measure 35 3/4 x 36 1/4. Wondering if they are repairable. Thanks ... (cont.)