Viewing all customer Discussions for:

Door & Window

I have 4 windows and all 4 the roto p4000 assembly fell apart do you have replacement parts? Best regards,

I am looking for this part #3850 - see attached photo below from your website (first photo). Do you have this in stock for left window (as viewed from exterior). See also photo of window from my home (second photo)

Looking for this. Not sure name

I need to get a couple of theses window balances

Had this piece that had a metal pin in break...Can it be replaced? Looks as if it is encased in the channel

I'm looking for a plastic piece that stops the balance from going up past the window. It screws on to the window.

I need both left and right parts to fit my window 23" channel length Overall length 24" 2230 is stamped on metal channel

Good day try to look through your website and get an answer that way but I am grateful that I found a email address for you all. This unit is 27 inches long and I am looking for a quantity of four. The measurement for the bottom shoe is very close to 28/32 which is 7/8 inches.

Hello. Trying to find part #2930. Bsi. Window balancers..Is there a different part # now for that part. It is 30 inches long and half inch wide on top with those extra wing plastic on sides...thanks I'll keep looking Ray

Length is 26 5/8". Stamp is 26 9. Milgard over 20 years. I need a total of 4 balances.

Stamped number: 28DLength: 29" I'm in Connecticut right now and this is from our place on Florida. I was hoping to bring new ones with us when we go back in April. the window sash is hurricane rated, heavier and thicker than a normal sash.

Missing the catch. Would like a new set please. The swivel lock is 2 3/4 wide x 1" deep Me a The catch is 2 7/8 wide x 1/4".

Hello, I received the new wheels they are once again the wrong size. I enclosed photos so you can see the difference in the wheel size. (Purchased both 81-138 and 81-189.) I will wait to hear from you. Thank You,

Hello, Attached are pictures of the locking piece I am looking for. They are aluminum windows' that the entire neighborhood has and are 28 years old and all have them. I looked for a manufacturer name on the side of the tilt out pane but did not see anything. The part is 2" long and has a metal ... (cont.)

Swisco, Per our telephone chat, here are some pictures which hopefully will be sufficient to ID the correct replacement balance. The metal 'U' channel is 26 inches long and 'stamped' on the side '26C' by Pella.

I have security storm doors on the front and back of my house. The original door locks had matching keys The original mortise latches for those doors wore out I bought two replacement latches from you, part number 40-194. I had hoped to keep the old handle sets and lock cylinders but they did not ... (cont.)

I need to purchase a couple of these window latches.I hope you can help, you normally do.I believe they are for sash windows?Regards Paul

Need to match these up please

Hello, I need assistance with identifying and ordering the following parts: -Window crank (the only visible markings are "45054" on the underside). The crank has 12 teeth / splines. -The arm that moves when you turn the crank. The plastic roller on the end (which usually stays inside the housing a ... (cont.)

Hi Swisco, I was wondering if you can help me identify what kind of window balance I have. This is a single hung window. The balances sit at the top of the window (circled in red). Since the two cables are broken I was able to remove the balances with two screws and not have to fuss with the hooks a ... (cont.)