Viewing all customer Discussions for:

Door & Window

Looks like a typical channel balance, only has the numbers 28 3 on it. It's probably around 16 years old.

see subject

I have a Jeldwen single Hung window with bad balances. They are 28" long metal To metal. Stamped 28D. The 2 ends need to be the same as pictured. It did have strong and a spring inside but broke.

Hi I need help determining what parts I would need to fix my windows that slam shut when you attempt to open them. I would need these for 4 windows.

Hello!My right handed awning window operator broke. I need a new part. It has 2 holes at the bottom but they are not on the same level. One hole on top. The arm lenght where the hole is measures 2,9 inches (from the back).Could you please direct me to the correct piece ?Thank you!Regards,Angelo ... (cont.)

The patent # is 3596954. The wooden part is 11 inches long,about 1 1/4 inch wideRegardsDavid

Need to replace Milgard window balancer. Left side of window. Number on metal is 26 5 GW CMC 4. Metal part is 27" long. Pictures attached. Please let me know if you need more info.

Looking for this channel balance 2630. 27" long. 5/8" high. 1/2" wide. I'm not familiar with the bottom guide. The rollers are inside the plastic guide and the wings are extra long. Can you help?

Caption says it all...looking for the "fork" type gadget that is placed on the inside of Pozzi window to open/lock. Looks like a tuning fork and I've had the "tines" on a couple break.

I need the latch and screws for a patio door

I only have small piece of the part

I need to replace some of the Pivot Lock Shoes on my Simonton Windows. I believe they were installed in 2007.

Hi, I am looking to replace a left and right hand crank cover for a Pella casement window. The back of the part has the numbers "C-1278-620."

I don't know what brand these windows are but I'm looking for a locked it looks like that

Hello, I'm looking for a replacement lock for this window style. I believe it's a Swisco window. Thank you, Scott

I'm trying to find a replacement window balance spring for an Atrium window installed around 2010. It is stamped 18 3. The aluminum channel measures 18" long. I know how to remove and install the balance spring. I just need to find a replacement. I've found a Caldwell brand on Amazon with the same ... (cont.)

Do you know what this glazing bead is? On a casement window.

I have Anderson awning type windows in my house, they have become difficult to open and close. The house was built in 1958. I am looking for replacement hardware becuase they seem to be worn out. I am greatful for any help you can provide.

80 in outgoing patio door need the lock

Attached are photos of the crank handle. The measurement are 3 1/2 " x 2 1/2".