Viewing all customer Discussions for:

Door & Window

0m137 patent pending is the only thing written on them. there are four per window (2 each side) with the one bumper on each side. I have three windows that need these mechanisms and coils replaced. Not sure which parts are appropriate aside from the bumpers--ThanksDavid

These are in a low income rental... so not high end windows. The latch is the slide in from the side type. My example piece is broken on one end.I need 8 right/left sets initially. If they fit I'll order many more. ...rehabbing a small apartment complex. Currently rehabbing 4 units. Will need 8 latc ... (cont.)

Hello, our carpenter is having a hard time finding the correct crank for an old window. The stamp on the crank has the name Anderson on it. Any ideas about what he might be looking for or suggestions to find the right part?

Please help me with product identification. The unit is good, just my crank seems to be the problem. Should I replace the entire unit or can I just replace the crank.

Need replacement

One piece

I need 4 of these pleaae

Picture of windows 2. Of missing part needed 2. Of parts intact. Thanks for your help

Hi - Looking to find matching kitchen cabinet hinges. Thanks

My lock has fallen down inside of the door and the hole is smaller than the lock so if I buy a new one how do I fit it through that hole?

Length is 27 inches. Would you tell me which model I need to order? I like to order 12 pieces.

Andersen Awning operator shoe

Vinyl sliding door track insert is warped. Approx 3 1/4 inch wide, runs the full length of the door. Needs replacement.

I need window balances for our Alenco windows. The stamp on the part says 2330 J

Hi, I'm eating help making sure I buy the right balancer. Attached is a picture. Thank you.

looking for replacement lock cylinder and keys.

I need a pin that is about 1.5" long with a flat spot that connects the lower window to a metal cylinder that slides in a track to raise or lower the window.

I am needing to replace some window coil balances (Also known as constant force balances). I am enclosing a picture of the measurements of the coil balance that I made from one of the broken window's coil balances, I think the measurements that I have made are close but I was using a tape measure. ... (cont.)

I need 2 balancers for a Milgard window. The metal channel is 33" long 1/2" wide and 9/16" deep. Can you help me?

Hello, I have a bay window with 2 side windows, house built in mid 70's and these might be original or form the 80's We'd like to replace the operators (need 2 Left/right) and the window locks (maybe series 24?) (4 needed). Once the windows opened the arm shows a number "30752" I am thinking it wa ... (cont.)