Viewing all customer Discussions for:

Door & Window

Hello,two years ago, I had new windows installed and Home Depot never installed the screw covers and some weep hole covers are missing too. I don't get an answer from them, so I'm trying to find the parts elsewhere.I need 80ft of screw covers for the picture windows and 5x weep hole covers for the s ... (cont.)

Hi - looking for this profile of gasket for some old aluminum storm windows, thanks!

I'm looking for replacement parts for window vent stops. The openings measure 1.063" x 0.189". Ideally I'd like ones that can come out and retract so my windows can open fully when I'd like.

The latch on my sliding glass door broke. I'm having trouble finding the right replacement part. The thumb latch seems to be about 2 6/16in long. The metal pin is 1 inch. I can't find a manufacturer name anywhere.

Attached are three (3) window parts that we are needing to get replaced. Are you able to help me figure out which part this is so we can get replacement parts ordered? Thank you, Val

need help finding this plastic part for the balance both sides of window and how to replace, Thanks!

HOW CAN WE GET A CATALOG FROM YOU. WE WILL PAY FOR IT. WE NEED TO ORDER BALANCES & WEATHERSTRIP. YOU HAVE EXACTLY WHAT WE USE AND MORE. THANK YOU- DEBBIE

The lock handle sheared off. Do you carry this lock?

The only markings I see are Semco on the crank handle and EntryGard on the crank arm. Hope that is enough to match. Thanks!

I ordered the 39-031 EntryGard Dual Arm Operator and installed it, but the window will not close the last few inches. I noticed that the original operator has a Link Arm with an upward offset, while the replacement 39-031 has an downward offset, and it appears that the downward offset is causing th ... (cont.)

I need help finding this screw spindle for this type of handle. The screw part of the spindle is damaged and won't open up the enteygard window crank.

Muli-point mortise lock 12 1/2 inches long, two screw holes 12 inches apart. Width is 1 inch.

Where can I get a storm door latch assembly for a 10 year old door. Lowe's was no help at all.

Looking for a replacement part that is damaged. This is an older window--at least 25 years old. The Bay window has three sections with windows that open and tilt out on the top and bottom of each section.

Hello I am looking for an attachment. The window specs say Guardian Kingsburg, Cal ANSI Z97.1-1984 Safety Tempered SGCC 980 3/18U 18 CFR 1201 II CAN 2-12.1-M79 Attached are the photos of the part I need help identifying, one is the broken Piece thank you

Need help finding this gazing bead.. need lots of them.

Hi there, I wanted to see if you have any replacements on this lock possibly?

Looking for both sides

Hi,Can you identify this part?This is located at the top end of the sliding portion of the window. Since its broken, it is not pulling the window balance that I recently installed. Yesterday I received that balancer that I bought from you. Thanks you so much for your assistance.-Frank ... (cont.)

Overall length of 22 inches. Both retainer clips have come off but we only have 1 of them.