Viewing all customer Discussions for:

Door & Window

Hi, the channel balances on a single hung aluminum window has failed. Based on your parts identification guides and steps, I believe the correct replacement parts would be 17 inch series 351 option 1620 - the window weighed 8.6lbs, no markings visible on the failed balances. Can you confirm from the ... (cont.)

Channel balance series: S395Channel length: 10 inchesChannel stamp: 2130 CQuantity: 2Comments: I bought the 11 inch S395 and its too long. Everything is good about it but the length. i need it one inch shorter.

Customers needs instructions on how to install part 39-363.

The part that hooks the pane to the slider (shown in the picture) rusted and broke. I want to replace the slider and the broken part. Not sure how to extract the slider shown above. Claude

I need to locate a few replacement window balancers. The current ones have the markings in the picture. Can you advise the correct replacement part? The metal part is 28 inches long. This is a tilt window. The width is 0.5 inches. I don't see any tabs on top, and the bottom is T shaped (1 inch ... (cont.)

Good morning - I need replacement cranks for left and right casement windows

I would like to purchase if you have them the top and bottom corner keys for an older Larson storm door top sliding window frame. They are very similar to the 95-140 and the 95-002

Nee to replace balance sash in attached picture also missing retainer clip on opposite side

The metal part of the balance track is 29" long not including the plastic ends.

Metal Channel = 27" I need a pair to try and see if I can replace it. If I could, then I have over 15 windows that may need repair.

Looks like your 82-108 but slightly different size. 7" long. 1 1/8" wide. Hole spacing the same 4 15/16.

I'm not familiar with this type of balance on a double hung vinyl replacement. It appears the pivot shoes are broke. Gibve it your best try. Thanks

I have a 29 x 58 Tuscany DH needing balance coils both sides. Not sure what weight of coils i needvto buy or if I need to double the coils up. Any help would be appreciated.

I need four window latches for Dove replacement windows. I purchased these windows from Dave when he was in Camden. My son went to Holy Cross in Delran.Thanks Jim

Which crank should I be looking at to replace a Truth 4524 12? Thank you

What type of hinge is this and where can I get it

Hello, Looking to replace two sets of crank out long straight arm window openers. It does look like the arm is attached in a floating track with a screw. The arm looks to be approximately 8" from where it bends and maybe 1" from outside to inside where the crank house sits inside the window. Can y ... (cont.)

Our home was built in 2005 - we bought it in 2013. Opened a garage window for the first time and the balances fell right out, spring and pulley, too - both sides! Looking for replacement parts. Amy help would be greatly appreciated. Label reads PGT Single Hung Window SH-4000 Balance is stamped 36 ... (cont.)

Hello,Could you help me with replacing a part on windows that has become broken/ cracked.We believe it is the sashes but unsure so including pictures. Need 6 of them 33 in length. Thank you.

I have a window that needs tension springs and release clips for fold out of window. Serial #: J 34106Y4304 W or M