Viewing all customer Discussions for:

Door & Window

This piece holds the window screen so it's not flopping around inside the window. I would call it a retainer clip

Hello, we are looking for what we think is a pivot bar. The window is marked 28B on the left side

I have these windows. I need the guide shoes for these windows.zb vs

In the picture with numbers, #1=1/2", #2 (distance between screws) =1 3/4", #3=2 3/4", #4=3/4"(this part fits into the 1/4" channel on the sliding window), the part that fits into the 1/4" channel is 3/16".The color of the pull is antique bronze. I need 8 of these (most pulls are broken). ... (cont.)

Hello, I have a bay window w/ two sash windows on either end. I don't see any name or numbers on any of the parts.But this is a photo of the guide I need in white. I would like to buy (4).Thank youKellee

I have a Channel 28c , spring loaded , can I buy the whole set up all together ? I am sending pictures to let you know what I have I noticed there is a pin h9olding the bottom . let me know what you think Thank You

I have a house built in 1990 that has Andersen permasheild windows and my glass retainers need to be replaced. Would product #55-301 work to replace this?

I'd like to replace my existing handles with ones that have exterior locks. Are the attached photos sufficient for identifying a replacement?

That is the one of doors I need for 6 of them

Need to order whole door handle assembly. Thanks

Need balances. I don't know if I need new clips or not. If I can use same ones that are here then I will. I am going to need 16 balances.

Looking for 2 sash assembly. 54x 77. H LC50 series 437

Need Viking balance # 2830M Thanks Jim

spring stamped 406 unit is 2 1/2" long about 7/8" deep(in channel) 1 1/4" wide(in channel) spring and spool are 3/4" wide

Measures 29" long and has marking which look like 28G (or C) and USB

08 pat# 5,139,291 M Patent 4610108

Where can I get the fuzzy adhesive pieces that go in slider tracks for gaps between each panel.

The coil balance broke and need to replace it. To be safe, I'd like to replace the whole fixture. Need assistance with identifying the right parts to order.

Need both right and left operatorThe # on the operator is 30908The arm is 4" from rivet to hole

I have not found any markings on this new handle but would to make it into a keyed lock is it possible with this style and what would I need to purchase