Viewing all customer Discussions for:

Door & Window

Windows are developing a bit of rust on arms at bottom, though the big issue is corroded lower slide shoes that disengage from the hinge and then jam the windows to prevent proper closure. Would like to see if you can identify the parts we should order based on these photos. All I could identify on ... (cont.)

These are from several Harvey double hung, tilt in windows installed in 1998. They seem to clip down on top of the pivot lock cams in the jambs of each window, on both sides. When clipped on, they seem to hold down the pivot bars when the windows are tilted in for cleaning or removal. But I'm not ... (cont.)

I am looking for the tie rod bar/Tandem window lock rod. For this window.

My window Channel balancer looks like it's 27 in. But this is all that is stamped on the balancer currently. What model should I pick?

Please advise with parts number, I need 4 screen door rollers w/ spring

Hi. I'm having trouble with the window closing. As you see in the picture it's not closing completely. I used wd 40 and I bought a wrench from you to tighten any bolts. But it's not working. Could be the hinge arm?

Do you carry matte black finish?

Chanel Balance, similar to 3230. 30" except this is only 21". marking on balance is "20 4 EQ Caldwell Also need top sash guide that is appropriate for this window.

The outside handle does not release when the door is opened from the outside.

patio sliding door rollers deminsions roller width 1/4 inchwheel 1 and 1/8 inchlenght 3 and 1/8 inch or 4 inch to end of rollerwidth of copoent is between 9/16 and 5/8if you can help would like two rollers

Hello, I am missing a couple parts for a window that I have. I am sending a couple of photos one of the window that's missing the parts and another one that has the parts. The window has a manufacturer code of ELL-1 and series 800/850Thank you

mine is 23 3 is 23 3/4" long looks like your # S395-24 also do 16-002 take out clip replace plastic ones ?

Hi? Do you have replacement for the roller in the picture below. I need two. Thanks.

Hi, I need a new crank like the pictures show. Please advise which model is appropriate. Thanks Andrew

These clips are handed, left or right, and are mounted to the side frame. When the jalousie windows are cranked closed, the bottom of the frame of the window, which overhangs the window itself, slides under, and then up behind the clips to close the window. There is a number on this clip 420 L or ... (cont.)

I recently moved into a home with a sliding glass door that has possibly your brand. Currently it has an up/down interior lock. I'm Curious if you make a lock which has a key or keypad replacement handle? Thank you, Cheryl

Metal is 8", 7-1 AI5 CMC is stamped on it, 1/2" wide, channel balancers from vinyl window. Brand unknown.

Our house was built in 1949. Our wooden double hung windows are original. We are needing to replace the mechanism that allows the window to open and close. In looking at your website are you able to direct us to what hardware we would need? The windows are 59" tall. We have attached photos of a wind ... (cont.)

Hi, Looking to replace door hardware and locking mechanism. Please identify replacement Thank you!!!

I please help us find replacement parts. The window sash is approx 51 wide by 28 high the numbers on the channel balance are 25-9 AA CMC 7 Also 61-259