Viewing all customer Discussions for:

Door & Window

I need the replacements for this windows. Simonton brand. I can see the part number on the plastic part has 801020. Also included a picture of the metal part.

8/2/25 Deck dbl door handle: 7.5" long 4" between holes 15/16" wide

I need a tilt lock for a Ply Gem window right side in a beige color. The one on the window isn't holding the window securely.

Handles to open and close windows

Our larch broke. The lever that locks the window just moves up and down...no longer connected inside the mechanism

Hello! We recently purchased the beautiful original 1950s Cape Cod with all the original crank out windows. Of the 23 crank outs on the first floor 19 of them are the exact same size (thankfully!) and are approximately 16.5" x 48.5". We are looking for replacement parts primarily for the cranks wh ... (cont.)

I need two of these, one for each side, for another similar window. The window I need these for will not stay open.

I need replacement for this window and I need the little side balancers that let it pivot and up and down (pictured) what is the model of the window?

Please help me identify the attached rollers (or compatible replacements). They came out of an SGD-R20-96x82 sliding door, probably installed in the early 2000s. Unfortunately I was not able to get a picture of them installed, but they install by only one screw (pictured). Thank you for your help. ... (cont.)

Window is 43: x 60" Looking to relpace broken spring

Identical or functional equivalent. Arm is 13.5" Label on arm says "Truth". Sill opening is 4".

Please help find a replacement part. This snapped in half and needs fixed. Also need matching shoe

Could you please advise on the correct replacement part for above window balencer. Its about 20 years old Thank you

Length is 25.75. Picture added is stamp. Quantity is 4.

Hello, We are looking for (1) window hinge. Please see the attached image reflecting the dimensions.

I am looking for a replacement for the pull handles on our sliding patio door. The screw holes are 5 1/8 inches from center of hole to center of hole. The screws are 2 1/4 inches long. The door itself is 1 3/4 inches wide. This one did lock but I don't necessarily need one with a lock. The top ... (cont.)

The pin that the handle fits on has sheared off in the handle, do I need another crank mechanism or is there a way to replace just the handle and pin?

Need both rollers

Hardware Identification.

Hey there, I am needling to replace channel balances and pivot lock shoes on my windows. Attached are com pictures. The length of the channel balance balance is 34 inches, and the stamping on it says (see pictures) "33HD BSI". The balance in the photo is very broken, but I think it will work for ide ... (cont.)