Viewing all customer Discussions for:

Door & Window

This is part of the latch that is attached to the frame. It broke in half.

I need to replace (4) 1/2" Wide Channel Balances with a length of 27". The stamped number is 2640 but I'm unsure on the attached endpoints.

Hello, I would like to order 2 coil balancers for my window. Also, One of the screws for the plastic piece will not tighten into the side of the window sill.....almost like the hole is stripped. Should I just find a little thicker screw? Any suggestions? Please see the attached photos. Thank yo ... (cont.)

Will this item fit Milgard Mendocino Sling Patio Door?

Can you supply the part shown in photos? Thanks, Jim

Need 30 of these It seems that the top piece of the block and tackle does not hold up ,likely from to much friction on tubeCan I buy just the top piece of the block and tackle

This is from a Jeld-Weld half round window purchased from Home Depot around 2001 that was completely destroyed by a large hail storm. I'm attempting to find a replacement part. Does such exist that I can purchase? Matt

20 year old Florida room. 4 panel windows that are aluminum frame and plastic film. The clips slide left and right and holds the window section in place and allows you to slide it up and down. They are plastic. 2 per section so 8 per window. Hope you can help. Thanks a lot.

Made the mistake of using a small town general contractor to replace all our windows a few years back that is useless. We had what I refer to as a night lock that prevents the window from opening more than a couple of inches, break. It has taken me a year to get this far. A lady from Norandex that b ... (cont.)

Mortise and handles with lock Thanks in advance

Hi, I'm quite sure this is the replacement beading I need based on the photos and measurements. My windows, however, are longer at 68" x 43 3/4". What technique do you recommend for installing the lengths that are wider than the manufactured length of the bead?

The number stamped on our springs is 6#. Is that a 6 or a 9? Does the # symbol refer to "number" or "pound"? Dan The Series 180 Coil Balance is a stainless steel roller-tilt coil. Coil spring sash balances are also known as constant force balances. The coil measures 15/32" wide. Before you pic ... (cont.)

It is plastic 2 1/4" long, 1/2" wideIs on window installed 2004. Certainteed name on a latch on another side of window.The part is located in the bottom track of the horizontal sliding windowMy photos appear to be rotated 90 degrees.

Can you help me identify this part. I tried to locate it, but cannot find the right curve. Thank you for your help.

Just want to make sure I purchase the correct parts. The window opens to the right (looking at it from the inside of the house) Think I need the following: -ENTRYGARD DUAL ARM OPERATOR Product Code: 39-031 -Truth Hardware Operator Cover 39-107 -Crank Handle, 11/32" 39-114L Is the color beige? ... (cont.)

This is a casement from the nineties has a crank out and pivot hinge which is rusted

I am building a sliding glass door out of steel in a metal shop. I am looking for a lock mechanism and lock trim in flat black that I can use to hold the doors closed with a keyed lock also. I am familiar with Pella, Andersen style patio doors. Having said that, I can build the door to receive an ... (cont.)

I purchased 2) 28" Series 385 Channel Balance...I need the plastic cap that is on top the window channel...I getting ready to order 6 more 28" Series 385 Channel Balance for 3 more window and need to replace this cap...hope you can identify it by the picture...thank you Mike

Need to identify the right style of glazing bead in these photos

Do you have a replacement available for this window lock? Thank you