Viewing all customer Discussions for:

Door & Window

Hi, This is from a Florida 50s era home. It is right-hand position. Has a worm gear insert that falls out. The handle crank is attached to the worm gear.

Hi there, My tenant took parts off of the patio door upon moving out. I am now lost on what exactly we are in need of. It looks like everything is there for one side of the door but, nothing on the other side.

Trying to find a replacement for this lock

I looked through the page of single wheels and didn't see one that matched exactly.No screws needed to mount, just pops out with a little prying.

Good afternoon, I am hoping you can find this casement window crank handle. It is terra-tone color. Thank you in advance for any assistance you can provide. Thank you, Andrew

Hello, I have purchased parts from you in the past and hope you can assist me again. I need to replace the wheels for bedroom sliding closet doors. I need to buy 4 to 6 units. Please help.

This letter is to see if you can provide some feedback and guidance to my spiral balance dilemma. We have a sash-type window that is overall 48" wide x 60" tall. The bottom sash and the top stationary window are approximately 48" wide x 30" tall. Servicing was necessitated because the right side p ... (cont.)

House built in 50's - these tabs hold in storm windows

Hi, I?m in the process of replacing the balancers on 4 windows. Sachet weighs 19.5 lbs, and metal length is 29?, but it is very hard to read the code imprint on the metal. I took few pictures to help you answer the question. (I narrowed it down to the S380-29 or the S385-39, but I need help with fig ... (cont.)

The entire lock mechanism and handle needs replacing.I am unsure if the key works the outside lock, but that part may remain the same if needed.Please help me identify which replacement parts I need.Thanks,Stacy

I need a door handle that extends no more than 1.75" from the door surface where the handle is mounted. What products do you make that fit that specification? Thanks.

The metal rail measures 25 inches. The trail is 3/8" wide.Numbers printed on the rail are: 8 240XI need to find replacements like this one and not sure which one to order. I was looking at the 800 series but not certain.

I need a replacement balancer for a Milgard window single hung, non-tilt but I'm unable to identify the part number. The only info on it is printed (not stamped) it states: 32 4 GS CALDWELL. The metal part of the balancer is 33" long. The window was new around 1998. There is a label on the top of th ... (cont.)

Hi My name is Joseph. My window is a certain teed 45 X 48 (approx.). Lower sash tilts out, top fixed. The coil balance is stamped S 361. Need two. Thanks

IS CODE 82-400 THR CORRECT ONR?

Broken metal ring for a thumb turn lever, the broken piece engages and disengages the double hook lock, can not find this part anywhere, any suggestions?

Hello can you help me to identify the correct channel balance and shoe for my window? On the channel balance it does say 3150 Thanks for your support

They are either broken or missing , no markings on them just made of plastic , slides side to side so can lock window in place or to unlock and pull window out to you.

I am looking for replacement vent locks for my aluminum awning windows. House was built in 1979. I think the windows were made by Alcon. I vent lock in pic2 is a broken one which is why I would like to replace them.

Hi I have a very old window that I am missing one of these parts I do not have the ability to get the brand name any information you could give me would be great the window is a single Hung aluminum window this guide goes on the side of the window that fits in the guide track to keep the window from ... (cont.)