Viewing all customer Discussions for:

Door & Window

I have Alenco Winddows that are 57 years old and the window faceplate fell out of the window and broke. They are a dull silver and the latch works fine but the face plate is more ornate with the centre being a semi-circle (that holds the lock in place), and the sides of it being slanted slightly (in ... (cont.)

Hi, Is there a replacement part available for the piece in the picture? A bad wind storm kicked up on day and pushed both windows in breaking base. the windows still open and close while holding the inside piece in place. I think I really just need the grey plate that sits on the outside. ... (cont.)

I have a couple of windows where the cam has been worn or damaged and no longer rotates when the pivot pin is placed in the cam and turned. First question can the cams be replaced and if so how do you get them out? replacement cams available? If the cam is not available, do you have an assembly a ... (cont.)

Please see the attached pictures of a white plastic balancer catch from the top, outside edge of a Milgard Single Hung window. I would like to be prepared and order enough for all my windows. Put me down for 16 units. Thank You Addison

See part number on one of picture

Am looking for the balance for tilt window 28C

Hi. I'm tired of my windows falling and I would like to purchase 6 of these retractors. Are you able to supply them to me?

I believe they are Hurd Windows, no markings. Need shoe and a few coil springs, maybe. 10 windows, double hung, to repair.

how did you remove the old shoe? it's in that channel and I don't see how to extract it without breaking it

Part # Stanley 00-5024 two roller, right orl left use

I need to replace a 1/2" Milgard channel balance. The top looks like your 19-005 part but it has an unusual shoe containing a pulley with the clip at the bottom (see attached). Looking at older posts I see you can make these as custom orders. The metal part is 25 5/8" long and is stamped '25 9'. Th ... (cont.)

I ordered the wrong size balances (S745-26 [25.25-4] and S745-32 [31.25-4]), the springs in the new balances are longer than the old ones and the cord might be too short when the balance is put in the window , see picture .I may have used the wrong weight of the window when I chose them I' d like to ... (cont.)

I need replacement tilt window latches (both left and right) for Imperial aluminum frame windows (photos attached). I couldn't find any names or numbers on the broken latches. I have several windows so I would need 3 left and 3 right latches. Let me know if you need any additional information. Than ... (cont.)

Hello; I had PGT windows installed 18 years ago. I am looking for the attached spring weights that are 10" long. I have bigger windows, I believe are the same design, I still need to take them out to measure. I am also looking for the rubber (insulation that is at the bottom of the window, to seal w ... (cont.)

I have the same top, shoe and metal clip as this original poster. My balance says 25 5 BSI. I would need to order two. Can you let me know if this is a possibility?

we have a 1984 Pella French door ox31ws. we need weather-stripping and bottom door seal. door is 5'11" x 5'6"5/8.

Do you have this?

Storm door handle replacement 5205696

Hi, I?m looking for replacement window balances and plastic inserts for securing cord end. The balances are Caldwell 3660 DK. They are 26-1/4? long. See pictures attached. Thanks, Rodney

I see your patio lock, Product Code: 82-040. Do you have such a lock with a keyed lock? I need two keyed slider locks for hollow core closet doors. They do have a wood rail at the bottom of the doors, so i should be able to affix such a lock to the rail. thanks!