Viewing all customer Discussions for:

Door & Window

metal is 23" long. Stamped "22 5 EP CALDWELL"

Need to order 2-4 rollers

Hi, I need to replace 4 broken channel balances which seems to be custom made as I cannot find them in your catalog. Those channel are used for Traco single hung impact windows (no tilt) Metal channel lenght is 24 in. The top seems to be new security 19-041 Shoe seems to be 15-004 ... (cont.)

Need to find replacement parts for window latch-- this is double hung window installed in a condo in approx 2001. Any/all help is appreciated.

I need to order 12 pcs of S795-26C with 15-198 hook This worked last time but the hook was a little wide and had to be cut. Is there a hook that is a little more narrow Bob

Before I order, I wanted to verify that I am selecting the proper assembly and that it will work in my sliding (non-tilt) windows. I am attaching pictures of my broken assemblies to show the top and bottom shoe attached as well as some coding on the channel. My channels are 34" long and 9/16" (effec ... (cont.)

On my windows the parts that let the windows slide up and down on inside of window are broken there are three windows these are vinyl windows and all three have broken on the bottom on both sides of the windows, there metal and bust into. When I try to open window it will open but not stay up sinc ... (cont.)

Need to replace 29? long balance. Thanks for your help. Dennis

I have double hung windows with the series 850 type shoe. The lower sash rod measures 28.25" and the upper 24". The plastic blocks on the top of the rods have broken and I assume I need to replace the entire system. There are no markings on the hardware that I can see. I would estimate that the ... (cont.)

Hi. I have a 1926 house with a sunroom. The cranks need replaced. They are approx. 6?x2?X1?. Do you have any replacements that would work.

Latch help

Need new storm door handle, cannot find one. Door is about 15 years old

This part slides into the aluminum window on the botton to hold the piviot bar in place. Might be an Accorn window.

having hard time finding a pull with the correct spacing of 6 7/8" to 7"

I'm looking for replacement balances for my Milgard window. Balance: Length is 33 in, Width 1/2 in and Shoe width is 1 in. The 2 balances have different numbers printed on them, which confuses me. Given this information can you provide the correct balances to order? Thank you, Steve ... (cont.)

To whom it may concern, I am looking for clips to hold screens in my windows. Unfortunately, the windows are greater 19 years old, moved into the house with these windows. Can't find any manufacturer information on the windows. Not the greatest windows. In any event, I have done my best to ou ... (cont.)

These are tilt-out double pane single hung aluminum frame windows designed to fit in concrete block construction. The metal portion of the balancer is 28" long and the spring inside it is about 18" long. I will buy at least a dozen of these if you have them. I need the whole assembly including the p ... (cont.)

I have old Alcan windows. Single tilt with broken channel balances. on back of channel it says: UNIQUE 10/31/96 15-0(?)-30The channel is 16"metal end to metal end and true 1/2 " deep x 1/2" wide. there was no nylon guide riveted to top and the bottom has plastic piece riveted flush to bottom. it i ... (cont.)

Hi I can't find any numbers or writing on this latch, can you please help me identify so I can order more? Thanks Mark

Hello Swisco, I am looking for two different pivot shoes. Both are for vinyl tilt double hung replacement windows. Both are 1/2" thick. Pictures show some intact pivot shoes and the broken ones. Any help or recommendations would be greatly appreciated! Thank you, Ian Swisco is a super great res ... (cont.)