Viewing all customer Discussions for:

Door & Window

Only marking is 28C SB on cord end of balance. I think mine is S385-28. Have purchased from you before, but probably 10 years ago.

This side is OK The other side on the left widow is rusted and I need to replace the hardware. Please tell me what to buy. This is a MARVIN widow casement circa 1990 or so.

Channel length is 13 and 5/8 in. The stamp numbers are 13 and 2 I need four balances

Looking for replacement wheels for this door

I'm looking for the crank assembly for an awning window. Having trouble idenitfying it. Can you help?

3/4" offset right hand pivot hinge for a Vistawall commercial storefront door

I am looking for TILT LATCHES for my vinyl widows. They measure exactly 2" from screw hole to screw hole. The entire latch is 3.5"long.The numbers on the back of the latch is H-786-LH on the stationary part and H-783-LH on the movable portion.Anthony

Please advise if you have the vinyl glazing glass stops as per the attached. I have sent pictures of the profile and a drawing that has the measurements.

hi folks, this part broke and fell out. The one on the opposite side of the sash has popped out, but I don't think is broken. Could you please help me identify this part and give me any instructions for replacement? Thank you

Pivot shoe lock needed and tilt lock mechanism 4610100 for shoe lock ---#4 for tilt. I think

The housing inside the window crank is stripped & needs replacing. Numbers found were 45002

I was not able to remove at this time, but will if I need to. Truth is stamped in one part. 40942-A is on the part at bottom on frame. This is a discontinued Seaway Mfg window from 1998.

these are clips that snap into the channel of the storm door to clip in the storm window

The roller= 1.25" diameter, 5/8" width, approx 3" housing.

The plastic pivot shoe broke. It looks like it screws on the side. Simonton window from Home Depot. I have changed other springs and shoes before.

Hi, Trying to find a replacement crank i can buy so i can open this window. the operator box is slightly painted over, but reads d-16 i believe, Thanks!!

Hello can you help me identify all part # for this mechanism please, thank you

Childcare building was built in 1999 by an architect who had no clue what kids would do to hand crank windows. Of the 32 windows in the building, only 2 handles survived (in the director's office). I need to identify these parts, buy and install.

Tru

I have a broken plastic latch piece that I am looking to replace. I am unsure if I can purchase the whole unit or if the latch comes seperate. I think i may need part 90-253 but i am not completely sure. There is a number stamped on the bottom of the mechanism of 45602. Thank you for your guidan ... (cont.)