Viewing all customer Discussions for:

Door & Window

Back in July I purchased part #26-234 from you. Now I need to order the part pictured that 26-234 goes in to. I didn't see it on your website. Can you help? Looking for 20 pcs.

FACE MOUNT KEEPER, 7/8" Product Code: 90-041 I am helping a friend replace some broken window locks and face mount keeper. How do I install this part of the window, lock face mount keeper? It is recessed, I am not sure how it is secured into the window itself. Thank you, Carol

I need the balance springs that goes with Part number 15-104. Caradco friction shoe. I buy at your website often under GCS company and I have not find this type of balance rods in your web site. Would be able to provide some information as to where can I find them? Any help would appreciated. ... (cont.)

I've got a window that has a broken pivot lock shoe. See attached photo. the bottom has broken and the cam will no longer stay seated. I can't seem to find a replacement based on the pictures provided in your catalog. Can you help.

Marked: 26 4 DQ CALDWELL Metal portion is 27 inches long. Metal width is 1/2 inch.

Looking to fine these for my mobile home.. needing at least 10. Looked everywhere can not fine

The stamp on the channel reads 32 9 DW CMC 4 This is for a Milgard non tilt window. The metal portion of the balance is 33". Which option under product code S385-33 do you recommend?

we would like to use these and the accompanying piece to secure decorative grids. How does this clip attach to the window best?

How are you? My window is tilted double hung. To change shoe and spiral balance(17"),I tried to separated window from frame. But I coudn,t it. I worry damage window. How do I separate window from frame?

I am told my slider needs its thumb latch replaced. Would your 82-106 fit a JELD-WEN slider?

the stamp says J50 5#23 8 79. This is for the right side. I will purchase one for each side. Which one should I choose?

Crank out window. split arm, similar to pre 98 Anderson. Just replaced both pre and a post 98 andersons in my house. the split arm has same slide clip to connect to post can take better pic in morn if needed.

Tilting window part worn out causing windows to fall open and break

Good evening! I need to replace a pivot shoe for one of my raise and tilt windows. Please see the attached pictures and let me know what part I can use to replace this one! Thanks!

I lost the lever that locks/unlocks the door. I need to purchse product code 82-227 with the 45 degree lever hole but I need the lever as well and I lost it with the broken mortise locking mechanism. Do you sell the 45 decgree lever to go with this lock

Im looking for a casement crank HANDLE only, for a MW window, with a male end i was referred to this company by plygem they have changed their handles and only carry the female end now. I need 7 of them in Taupe. Please let me know if there's anything you can do for me. Thank you Chad ... (cont.)

I need to replace the Hinge arm on my Pella casement window. It is about 4" long with 2 small wheels at the end with white plastic "teeth" attached to them.

We have uniframe windows which have a small pop-out thingamajig which allows you to leave the window open a crack but prevents the window from being opened further. One of these thingamajigs no longer will stay depressed making it impossible to open the window all the way. Can these be replaced (and ... (cont.)

Sash Springs 2330 18, windows are 20+ years old

I have ordered before from your company (26-350) and this part worked perfectly well. However I have an older home and different windows throughout I now need a different type latch and can not seem to find it in your web site. If possible can you determine what I need from the picture and let me kn ... (cont.)