Viewing all customer Discussions for:

Door & Window

One need to replace. I didn't know series

I need your help to identify the model. It's a 1/2 inch channel and 27 inches in length. Thanks.

Hi There, I need complete set coil balance (left and right) for my window. do you mind which parts i need? appreciated

Needing a pair of single housed wheels.

26-4 FES CMC 75

I have 3 Farley replace windows. I need 6 tilt window latches, 3 left and 3 right. I think it's your Product Code: 26-243. Is that correct? I also need a replacement for one of the lower tilt windows measuring 23 3/4" across by 18" high. See attached pictures.

I have anderson casement windows . I need 4 new cranks for them . Could not find any identifying numbers on windows themselves .

Hello, not sure on the parts on what they're called. Looks like a coil broke off on the right side and the window just wants to fall down then you open it. The part on the left side is now cracked as well. Hopefully I can get some help on what I need to repair this and order a few extras to have som ... (cont.)

Part that's spring loaded that holds window in place when going up and down

Alumco aluminized brand.

I have 2 casement window cranks that are stripped and the retainer has popped out. Both windows swing out to the right, latches on the left. Stamped marking on the main body are 'Made in USA ', 'Truth' and 'Entry Gard' on the connecting arm. The house was built in 1989. The crank assembly looks ... (cont.)

We need help picking a bottom spiral connector

Window balancer is 26" long and has "26 4 JP CALDWELL" stamped on it

I have an older crestline installed window. The crank is no longer working - can't open or close the window. It has a pin that should go in to line up with the gears so the crank will do it's work but I cannot get that back in to its correct place. I am wondering if I should just try to get a new cr ... (cont.)

The window doesn't have any stickers but another window says H-R55. I need the pieces on each side that hold the window up as well as the locks and the tilt lock.

I'm needing help finding the part number for the rollers on my sliding glass door. Please see sticker on door below. Thank you! SGD-C20/SGD-C30. Series PA-9, ANSI/AAMA 101-88, MST 15080

I have old window screens held together at the corners by plastic corner pieces like the pics I attached. The majority are broken or very brittle and would like to replace them. The dimension of the frame hole are 3/8" height and 1/4" width. Do you have a product that could help me replace these? ... (cont.)

The number 2620 is stamped on the back.

Only marks = Made in USAJust need the housing/crank not the window hardware (already installed) (Painters removed and then lost them!)

Missing sliding door lock