Viewing all customer Discussions for:

Door & Window

I need some replacement sash balances for our Anderson windows & I'm not sure what to get... so I saw your youtube tutorial and pulled back the plastic and recorded these numbers... My sash balance numbers: 11600-17 and S8103/12 87 or it could be S81031 12 87 but the one following t ... (cont.)

Hi, I have a window sash that requires a 14-1/4" Peachtree Balance Product Code: S745-14. The sash weighs approximately seven pounds. Is there a 13.25-3 stamp option for the S745-14?

Looking to replace a couple of these that are broken. There is absolutely no indication of the manufacturer of the windows to be found. Thank you!

I'm trying to determine what is the right channel balance to order for a clients circa 1985 Milgard windows. The measure 21" L 9/16" length and the only stamp on them is 20 C. See attached photos.

Hi , my name is Frank, I need to replace a total of 3 rights and 2 left handle operators like this. This one is from a living room window. The left side of this window , also needs the arm as well. Not sure if comes complete or separate parts. The other right and left are from a bedroom window that ... (cont.)

I bought about 25 tee type 39-298 for andersen casement windows awhile ago. My goal having rental property and people not quite taking into consideration the cost of replacement operators was to eliminate them getting broken due to the force 39-286 handle puts on the splined shaft. The tee type woul ... (cont.)

Hi, One of our window balances has broken (the line snapped) and I need to replace it. The only identifying mark I can find on the part is 2040 BSI GL (BIS is perpendicular to the 2040 and GL). I'm attaching pictures in the hope that someone can help me find the correct replacement part; I have tw ... (cont.)

Hello, I went through your website looking for this pivot bar; the width on the top is 1 7/8 to 2 inch, top bar down is 1 1/8, to the hole is 3/4" thickness is 3/16x1/8. The pivot shoe thickness is 3/8, Length is 2 1/8, width is 15/16. any ideas. thanks

This holds cabinet door shut in camper. The bottom part is broke off where other screw would go

I am looking to buy Windows Tilt latch for the right and left sides. I would like to buy 20 pieces. Please, review the attached photo and measurements. Thank you for you help.

Good morning. Do you have a corner key similar to the one pictured in the attached file? Thank you. Todd

I would like to know if I can install a lock similar to 82-316 at this door Thank you Alfredo

I'm looking to see which tilt latch replacement size better fits my windows, I've tried different one but haven't got the right one yet. ..the windows are Namibia manufacture stipulate NFRC 100. code.RIW Spec. NFRC Series.Poly weld dh MST. 4060 (Vsdh) Window size does D 301/2 60 1/2 Plea ... (cont.)

Hi I need two of these for our older sliding door. I did not noitice any markings but I think the door might be a pella. I hope these pics. If you have them could you tell me how much they cost abd I will order. Thanks Ron

I am looking to buy replacement channel balances - the metal part end to end measures 26 inches. Can you please help identify my part so I can order it. Thank you, Greg

Stamped with 8160 and a 3. Any clue? I need 20 of them! I'm not sure who made our casement windows. Thanks. Christina Ps. I purchased a Truth 22007 and it goes too deep into the wood peeling the pant, but cranks open the window properly.

need to id the attached spiral pic. 23 inches long, 5/8 diameter. did not see anything on your web site to match the bottom part of the spiral. no identifying numbers

I don't know if I see this combination of tops and shoes in your selection. Do you carry these?

I have a storm window with a gapping corner. I think it is a larson storm window. Would I use a Larson corner key kit to fix it? Thank you!

Hello, Could you help me ID the correct shoe. Attached are pictures of measurements of the old shoe, also a newly bought wrong size shoe for comparison. Half of the old shoes were broken in half, I forgot to measure the length of it before I put it back in the window, but I do have measurements o ... (cont.)