Viewing all customer Discussions for:

Door & Window

Bracket for rm-g1005

Which of your replacement casement window handles should I order

I need to replace the channel balances on 2 windows. The old balance on the smaller window is stamped "1490 DL 15". The metal channel is 15" and the "U" is 9/16 x 5/8. The window weighs 17 lbs without the channel balances. The old balance on the larger window is stamped "2690 28", even tho ... (cont.)

Good Morning, I am seeking latches for Jordan Windows. This is for a hotel so I will likely need a good quantity. The dimensions of the latch are equal to your 90-009 or 90-005 latch with the exception that the tongue protrudes below the latch approx 7/8" on a rod attached to the handle. ... (cont.)

Please help me identifiy this piece. Thank you.

Plastic part on the side of the window channel casing. Not sure if there are supposed be one on each side.

I ordered the wrong ones....I need the white tipped skinny one from the photo....I ordered the 31" red tipped ones which are too fat...THANKS!!!

I need to get a replacement pivot bar 265A.

Broken black pin - do you have the remplacement part. The fly screen is from 2008 ?

I'm looking for the top sash channel guide and can't identify which one of your parts is the equivalent. I have also attached a picture of the stamp on the channel balance. It is approximately five eights wide and 1 3/4 tall. Can you help? Don

I have the parts and was ready to replace the pivot bar that had rotted off on both sides of the upper window, but when I got the window out I noticed it was not like the bottom window that I just fixed where the pivot bar is exposed and easy to screw out. The upper window's pivot bars are covered ... (cont.)

Im looking for this window latch

I have tried to fit the below handle, but the tongue does not seem to go back far enough. When the opening handle (Black plastic) is in the up position,the tongue should be touching or close to touching the brown casing ( pull handle). On the one you have sent me it only goes half way, so the t ... (cont.)

Hello, I could use some assistance in identifying these screen corners so that I can order them from you. Thank you.

Please help select the correct window balance. I have attach the following pictures to show the ends of the 2740 style window balance.

I am trying to understand the Truth Hardware Universal Joint in detail. If you can please help me with the following questions or if you have documentation, it would be most appreciative: 1. Is there an alternative/competitors to the Truth Hardware Universal Joint for Skylights or is it paten ... (cont.)

Hi I need to replace the window crank operator for an old steel window. The problem that I am having with the parts found in the hardware store is that at the end of the arm where the circle slides through the slide in the part of the window that opens- on the opposite side of the arm - wher ... (cont.)

Each metal coil has the number 5 stamped on it. Please let me know as soon as possible. Thank you, Brad

I have two sliding doors one is 48" X 78" and one is 36" X 78". They are Acorn doors I need to replace the rolls on them,but I have no idea the replacement parts to order can you please help me. Thanks; Judi

Is this product available in stainless steel or brass? This is for a marine saltwater application 81-090 Do you also have parts like the attaced images? The part with concave roller is about 7/8" w x 3/8" d x 1 15/16" tall and the roller is 7/8" in diameter. And the other smaller roller is ab ... (cont.)