Viewing all customer Discussions for:

Door & Window

I need a pair of sliding screens w/bottom track for an existing french door pair. How does the 80-111 install on an existing aluminum threshold?

Our screen doors are very old, over 30 years but are in excellent condition aside from the springs needing to be replaced. I cannot find any matches locally nor can I find any information on the doors that says who manufactured them. We have open barrel hinges. One side of the hinge attaches to t ... (cont.)

I have new vinyl windows and the screens just slip in. If you bump the screens they just pop out. I was thinking of adding some sort of spring to help hold the screens in. Which type of spring would you suggest.

hwo do you remove and install the 15-111 pivot block?

Can the 87-087 also be used as a bootom guide? I have an older model home(1980 Country Cottage)I have been searching for replacements to keep windows from rattling and to make slide easier.I think these look like the orginals.couldn't get your picture to enlarge to really see.

On model 18-061, what is the distance from the top base to center of screw hole?

Where can I find 82-013 in a 4-1/2 size?

This 84-026 looks closes to my roller but to be sure I should remove it so I can get the exact dimensions. Can you give me directions for removing this item?

stamp reads 2900 bsi

Is the 39-121 crank handle made out of aluminum or what type of material? Thank you, Tom

For the Series 795 at 27 inch and looking at your current stamp number you most likely need the 27c stamp option. To check, remove the window sash and place it on a scale. The S795-27 with stamp option 27c will carry a window sash weight range of 17 through 22 pounds. This information is b ... (cont.)

Is this track (# 80-106) the only one you have? The one that I need to replace just sits free in the bottom of the patio door, and is 1 & 5/8 inches wide, with the "bead" down the middle. Will your track that is only 15/16 of an ich wide work under my sliding door? Thank You Greg Sandercock ... (cont.)

A picture would be helpful so we can understand a little bit better about what type of rollers could work for in your situation. Can you send us a picture of where the roller mounts to panel?

Finally! I think you have the rollers for my 35 year old slider windows I have been looking for (87-162)! There seems to be a set of rollers on top and the bottom. Are the top rollers needed or are they there if you turn the window upside down to use in the other direction upon installation. I don't ... (cont.)

Does Neutral mean the 26-188 can be use for both left and right hand side?

i think the 39-097 is the part i need....window glass 24 1/2"x 36 1/2"...mid 1970's....how do i remove the old one to check the measurements...thanks

Are the 70-174 latches the latches for Andersen window screens sold in 1981 thru 1988?

DO YOU HAVE A 4 INCH DOOR KEEPER ..IF NOT CAN THIS ASSEMBLY REPLACE WHAT i HAEV ...IT IS AN IN SWING DOOR INTO MY BREEZEWAY