Viewing all customer Discussions for:

Door & Window

I am looking for these balances. The markings on it say (11/2) UNIQUE 27-D-40 Thank you,

please help identify

I'm trying to find these parts that go in the top corners of the sash for aluminum windows with channel balances.

I need these two to match in size. Lock fits. keeper does not.

Metal rusted on top I can read "4 CALDWELL AN". Metal 24 1/2". Top 1 1/2" front to back. Bottom 1 1/16 front to back. Thanks Gary

Dear Help Department, I have an old commercial door that is dragging. I have narrowed it down to the top, left hinge. I would like to buy a replacement hing for the top and bottom of the door. Enclosed are pictures. I don't see any names or model numbers on the door or the actual hinges. I think th ... (cont.)

I am looking for a part NUMBER for a window opener. IGMAC HYALIN ST HYA SUPERSEAL 1992 and a supplier that can help to order the part Thank you

Hi,2 years ago, I ordered item A (see attached) and thought I was reordering the same item 55-062 (Item B) but it is too large. Even with Item A, I am having issues getting bead flush with window it is bulging out a bit. IGU window is exactly same size (3/4") as old as is the tape (1/16 x 3/8) so ... (cont.)

Hello.... I need some help in selecting which channel balance to buy to replace a number of "Unique 25 C 30" and "Unique 21 C 30" the shoe or end block appears to be the challenge (as shown in the picture).... the pivot shoe these connect to appears to be identical to your part number 15-105. Yo ... (cont.)

Hello, I was wondering if you sell this replacement channel. Please provide pricing and availability. These are the only markings I was able to locate: 32-5 HES CMC 45

The metal channel is 33" long and 9/16" wide. A marking reads 3230. There is also a BSI RC. It is from an aluminum window that was installed in 2007. I don't see a hook at the bottom of the balance. I'm not sure if this style doesn't have a hook or if it broke off.

I've tried phillips and brixwell with no luck on either. There are no numbers or marking on the glaze bead or window that I can see.

Hello, The metal piece is 26 in long and it is 9/16 wide. I would need four of these. I hope you can find them. Thank you Dawn

Kitchen drawer back plate.

Trying to find exact oart

I can't seem to find any brand or identifier for this lock on my sliding door. Do you have anything similar?

I broke my jamb liner pulling it out. So do you have replacements?

I'm looking to replace the channel balance on my windows. They are marked as 27-4 (photo attached) with bottom guides that I'm having trouble finding. If you can help identify the same part, I'd really appreciate it. Thank you.

I need four 18" Milgard window balancers

I am looking for at least 3 balance springs and 6 sash mounting plates See attached picture. Spring is approximately 29 inches by 3/8 inch thickPlate is 3 inches tall by 3 3/8 inches wideDietmar