Viewing all customer Discussions for:

Closet

Need a base plate for a sliding mirrored closet door.

I have a pocket door that never stays where it's put, it always travels back inside the pocket. I would like some type of swipe That applies pressure at the bottom the door to keep it from returning , one its own, into the door pocket. Respectfully submitted.

We are having pocket doors installed in our house. The floor mount door guide posts are installed proud of the door frame they are made of nylon and my concern is if they are knocked with a vacuum cleaner etc. they could break. Are these installed correctly should they sticick out like that. Please ... (cont.)

The 23-222C is perfect replacement for the Stanley 00-5024 roller. I just remove (well broke off the old plastic Stanley) and slid yours in. No modification required. Thank you so much. I just ordered more for the rest of my closets.

Mine are only 58 inches long can these be trimmed?

I am looking for the low profile track assembly that appears to be what is installed on the top track. The bottom track was discarded and later needed. I don't see that size option so can you make suggestion please. 2- 24" or a 72" cut to size? Or a vendor that carries that product. Thank you ... (cont.)

Doors are 49 years old and the pin pictured is for the bottom front (the part of the door that moves. It is held in place by a screw. I believe the problem is the broken plastic piece on the bottom.

We need to replace this 95-3/8" x 3-1/2" closet track. Please advise.

How much more would it cost to make the parts from metal ?? Or even rubber Plastics breaks too easily Just an fyi

I think I replied to wrong area. Looking for a replacement bottom of door. 72" long 3 1/4" wide and 1/2" thick.

Hello these are photos of the roller from a door I'm trying to fix. The screw bracket is bent and should pointing up relative to the wheels. There is a code " 41781 " on the body.

I need 110" track is that possible, you carry 72' Similar to the 23-242

Hi, These appear to be hung from a plastic or teflon slider, and one of the sliders shattered (see first picture). I'm not 100% sure I got the patent number right because the numbers are faded. My part looks entirely unlike another posting for this patent number (https://www.swisco.com/discussions ... (cont.)

I believe the 23-172 is for me but the barrel is 3/8.My measurements show closer to 7/16. I expect that will be a simple fix of wrapping it some durable material. Does this look compatible with my Stanley Stepped/Falnged Guide Wheel?

Hi, These plastic parts are used to guide the upper section of the sliding door. I need 4. Thank you.

What are the with/opening sizes of the Bottom Track Openings for Rollers of 23-241?

I would like to find track slider as seen in the attached photo

Metal pins are fine but need grommets with inner hole diameter 5/16" and bushing inside diameter 5/16" and pin cap 3/16" inside diameter and come spring 2" high , 5/16" and 3/4" diameter. I will send additional photos to make sure parts will fit. Also are there any videos on best way to insert long ... (cont.)

7/8 " closet sliding door roller assy. I need help locating these wheel assy. Also the doors are 1" thick. 30" wide. I could not locate any part numbers or brands

Can you assist with replacement parts for these rollers. Don't know the door manufacturer.