Viewing all customer Discussions for:

Drawer & Cabinet

I was inquiring to see if you have this particular item on your website and if so could you kindly point me to the right direction? Please review the attached photo for further detail. Thank you Gary

Replacement hinges for kitchen cabinet. Grass. made in Austria. Pat pend 1006-30. Other Inf on hinge is 048. Also circle with numbers around it and arrow in middle of circle with # 0 on 1 side and 5 on other side of arrow. I have ordered before. Thank you, Nancy

Marking on part MTP

Hi~ I am trying to replace this broken piece that we have glued together. I need help figuring out what the closest part is on your website. Thank you so much!!

This glide is on the back of the drawer. Part of the bottom broke off making the drawer unable to slide in and out evenly.

Not sure which is the one i need, bottom of opening looks like 1"-1/4"

Grant drawer slides 238 - 20". I need 2 pair. Photo enclosed

I have had trouble finding a replacement for this right-hand drawer track back plate. It was installed by a housing contractor, using Quality Cabinets hardware in 1991. The back plate is secured to a wooden rail on the back wall with one screw, and it has a ledge to hang from the top of the wooden ... (cont.)

I need some assistance. I am in need of a few of these. Can not find them anywhere. I would love to buy them from you if you carry them! Any assistance you are willing to offer me would be a great help. Thank you in advance

Looking for a Hughes H-1010 rear bracket for the L/H slider. They don't sell retail. Do you carry? Is there a substitute that will work or can you tell me where i can find this? Thank you for you help. Sincerely, Mike

There are no numbers, names etc. As you can see from the picture it broke at the top of the bracket. Please advise. Thank you for your assistance Kari

I am in need of some of these cabinet latches (see attached). The idea is that the depth of the back of the cabinet is 3/8, but we're putting 1/8 glass in the cabinet doors, so the latches hold the glass in from the back of the cabinet door.

its a plastic bracket that mounts flush to the back center of the cabinet it has a protrusion that inserts into the slide on both sides of the protrusion are 2 holes for small nails and farther out are slots for screws the left side is a horizontal slot and the right side is a vertical slot bracket ... (cont.)

Not sure how show you a pic thanks Gary

Broken drawer guide for thomasville dresser. Has 4 ball bearings that have fallen out. Roughly 16 inches in length and 5/8 in width. Any help is appreciated.

Trying to find a replacement for the right side.

from 1980's wooden kitchen drawer (American Woodmark)

Your 32-119 are an exact match for the G6600 brackets that have been around for over 20 years (and are beginning to fail!). If the old bracket has G6600 on it, this is the one to order. Thanks. JM Tampa

I don't see this exact shape on Swisco.com. The rectangle for the track to fit into looks like 13/16" x 1/4". I'm going to send you a broken sample in the mail.

the wheels are approx. 1-1/8 inch outside diameter and two are bolted at the bottom of each half-lazy-susan type shelf (at the 90 and 180-degree positions). the hubs appear to be aluminum. ball bearings ride in the channel between hub and rim. these cabinets are all-metal and date from sometim ... (cont.)