Viewing all customer Discussions for:

Other

I am looking for 11 8" branch cabinet pulls by Modern Objects. See attached pics. Thank you

Dear SWISCO Customer Service: I bought and received a 39-025 Awning Window Crank Operator replacement from SWISCO. At the end of 2-3/8 tongue on the crank operator, you provide a shoulder type screw. The shoulder screw diameter is too big and I cannot insert to the existing hole at the window. ... (cont.)

There are two latches, upper and lower. The upper will not move hence the need to lift the door when opening and closing. I need a replacement part.

When we moved in, the locking mechanism of this sliding glass door did not actually fit, and the handle was broken.

Photos attached, can't identify the right parts. Thank you very much!

Hi. Trying to find the following channel balance: 1/2 inch width 28 inches Non tilt Markings: 27 4 AJ Thank you so much!

Sliding door handle, says made in new Zealand. Does not have any numbers or other markings other than the squiggles on front. Screw holes where it attaches to door are 4 15/16 inches center to center.

Need 2 of these How can I order?

Looking to replace an Anderson window sash weight, measures 3" x 5 1/2" and has numbers 11600-17 or E46 9131 8-89

Hello!I am hoping to replace the block and tackle hardware for a sash window that looks like it hasn't worked right in a long time. One of the block and tackle balances is missing in fact. and the mounts in the window frame look painted over.The one balance I do have measures 22 inches for the cha ... (cont.)

697.043.59.00

(A) NEED 4 EACH OF WINDOW CHANNEL BALANCE "32-9 K15 CMC 34" WINDOW L=34.75 INCH CHANNEL BALANCE L=33 INCH; 1/2" X 5/8" WINDOW WEIGHT APPROX 32-34 LBS ATTACHED JPEG FILENAMES ENDING IN "XXX" AS FOLLOWS; BETWEEN 200 & 636 (I.E. 200, 636) (B) NEED 8 EACH OF WINDOW CHANNEL BALANCE "25 5 3S? RM" WINDOW ... (cont.)

Hi There, I need coil balance (Sears) for 19 lB Sash, Is your S140-10 right one to use? Please see my photo attached. Thanks a lot!

Approximately 2 inches by 1 inches for the assembly and the roller is 1 1/8 inches.

My living room has a 4-panel set of Certainteed sliding doors (Newcastle XT). The two middle panels move, and the two side panels are stationary. The two sliding panels lock in two ways: 1) mortise locks: These locks are doing fine. The left-hand sliding panel is equipped with three mortise locks, t ... (cont.)

I believe this to be a BALDWIN part.

Hi, I have a 30+ year old bypass door track for mirrored closet doors. The doors are 8' tall. The track is 130" long and I think the replacement track would be 2 of the 23-272 tracks joined together. The wheel assemblies I am unsure of. I think they may be 23-092 or 23-232S. I don't think nylon whee ... (cont.)

Broken lock on storm door. Number inside handle L-120.

Hello - looking to purchase two NON-TILT WINDOW CHANNEL BALANCES and not sure which to purchase; Series 380 or Series 385? Also what length - 20" or 21"? Stamp printed on it: 20 4 Length of the metal channel: 20-5/8" long, 5/8" deep, 9/16" wide and is "winged" or "guided" Provided image of windo ... (cont.)

9/16" wide, by 1 1/16" tall, the length is adjustable2 ¼" to 2 ¾"