Viewing all customer Discussions for:

Other

there are paper tags on the underside of the inner sash but all of them are faded and cannot be read. Need to know who made them so i can order parts from your company!

31230D ENTRY GUARD WINDOW CRANK

Hi folks, I have a Truth window operator which is in dire need of replacement. The number stamped on the part is R30842. Could you please tell me which part I should order, as I couldn't find that part number in your catalog?

I need to replace a few of these particular sliding parts

Sirs: I would like some help in ordering 2(two) replacement balancer for my windows. Checking your page featuring window balancers, I think that item S380 - 2875 would fit the bill. Please advise. Thank for your attention Flavio

Hello: I am in desperate need of two replacement crank operators for my porch casement window. They are Permaseal window. Any help would be greatly appreciated!

The silver metal arm is 30". Single pane windows that were the original windows from the home builder. I have 2 broken windows, both which need the left arm balance.

Hello, do you all have a replacement window balance for these? The window is Jordan and the sash is 46" wide and approx 34 inches tall

EMCO papaiz, no serial number, can you suggest a replacement please?

These were labeled as Somilgard classic vinyl awning windows. Supposed to have a lifetime guarantee but apparently because I live in Hawaii, it is considered a corrosive environment despite the fact that I live miles from the ocean in a valley, it's excluded. Wish they had pointed that out when I wa ... (cont.)

The lock assembly is missing from the slider door handle. I believe its the kind with a U clip that clips onto the door frame via a lever.

Hello, I'm looking for this parts.

15-192 is close to what we need. only thing ribs on pivot and narrower entrance for pivot bar. is there a different number or do I need to modify this number to fit

Need new rollers it's an 8' vinyl sliding door. I didn't think about taking them out and taking pictures sorry and the door is not at my house. See what you can figure out.

I have a Larson storm door, picture of model number attached. Latch is broken and I would like to replace it with a brushed nickel handle if I can find one that fits. Please advise.David

The patio door handle mechanism broke off. Can we replace it with a new one you might have in stock?

The cranks and latches are broken on a pair of windows. The windows crank open in opposite directions, I'm assume each crank device has a different pn. I don't have any information on the window mfg. or parts, they were broken when the house was purchased. Please let me know any additional informati ... (cont.)

House is 1900ish, best guess on door is 1980. Door is 1.5" thick. The cast piece that receives the screw for the knob broke, so I am looking for replacement hardware. I will buy anything that fits - one or two piece, not picky on style. It is 5.75" from top of top hole to bottom of lower hole. Each ... (cont.)

This is from a 60-year old rental house that we manage. We don't know if the door is original or replacement. Overall height of the handle is 4-inches. Mounting holes are 3.5-inches center-to-center. Only markings are "1B' on the outside piece and "2B" on the inside piece. In the photos the out ... (cont.)

Need plastic wheel 2.25"with 7/16" hole on centrr