Viewing all customer Discussions for:

Other

no name no part number, 2 1/8" long, 5/8" wide at bump outs, 1 1/16" tall

Need replacement latch. This is a 2 latch. The top one in the picture is stuck and will not release to unlock.

looking for same handles as 20-014 & sash latch in satin nickel finish

I need cranks for the windows that was put in 1989 when they built the house.

Looking for this window sash stop so I can replace the balance . It is broken just comes right out .

I would like to replace these window channel balance but am not able to find the SXXX number on the part. The following numbers are there on each part (for each side of the window) (1) 25 9 FT CMC 2 (2) 25 5 DV CMC 2 The length of each side is 26 inches. The width is 1/2 inch. The hook and nylon th ... (cont.)

I need this two parts

Atrium name on window lock

Need a multi point keeper for this latch my new sliding door didn't come with one.

Have a metal sliding door, says "International" on the handle. No other markings. I need to replace the rollers, picture of one attached.

I'm trying to find where I can get new balances for my single hung windows

Need replacement wheels for my patio screen door. Door is about 20-25 years old

The width is 9/16 and the length is 24 inches the k-23-4 I need 4 and the k-23-3 Ineed 2

Trying to identify this truth casement window operator part number. Guessing its about 25 years old as thats when i bought this house. Measurement of arm linkage are 8 5/8" long outer leg rivot to rivot, 7 3/4" long inner leg measured from rivot to edge of sash. Hop8ng for part number and price avai ... (cont.)

We are in need of the whit cap that goes on top of the black base to open the windows.

Clip that holds screen in place.

I need 4 replacement wheels for my mirror closet doors. The wheel diameter is 1 1/4. There are no markings or names on the roller I removed. Anthony

Good Afternoon,We have 4 CareFree windows which have broken bottom where the pivot plate attaches. The window are unable to open. Is there a replacement bottom for the windows or an alternative repair?Thank you in advance for your response.Roberta

The crank needs to be replaced. It would be very appreciated if it can be identified so that a replacement can be purchased. Thank you.

Not sure about the correct part,I purchased some pivot shoes from you years ago and they worked after I enlarged the hole, but they are a bit loose in the track, about a 1/16 too slim. maybe you can find me the perfect fit 3/8 " thick 2" long 1" wide