Viewing all customer Discussions for:

Other

34C pc BSI is the lettering I can find on the metal bar; I would appreciate help in locating the replacement and a video instruction to install.

No markings are found on the hardware. Each set of rollers (2 rollers per set) has and adjustment screw and a screw to attach the mechanism to the door, one mechanism on the right and one mechanism on the left. I have two sets of patio doors that need replacement rollers.

Kinco window from a home built in 2003. the metal is 29" long and 1/2" wide stamp on the back says 2850

this is for a Kinco Window on the home built in 2003 the metal is 30" long and 1/2 inch wide. there is a stamp on the back that says 26 9 and them some letters i can not read.

Crank is striped out and lock needs replaced

need to find out which one will work for me

Window was installed 10 years ago. The keeper has a small cut out so that it can sit properly on the frame of the window.

Can you tell me the name of the cover and if you have available to purchase?

The sprocket inside handle has lost some teeth and won't lock.

Double metal trolley, body is 3 inches. width is 5/8, wheel diameter is 1 inch, overall length with trolley is 4 1/2 inches, pressure fits with 2 tabs on side and 1 screw on the end

Can you give me the length of the locator pin on this wheel? Thank you

Hi, I'm trying to determine what parts I need to replace the bottom door sweep on my framed aluminum shower door. I've attached 3 pictures for reference. The door width is about 22 inches and the glass is 1/4-inch. Thank you.

Need help with replacement of broken glass block vent

Truth hardware Anderberg MG31865-CRebecca

Please identify the part name in the uploaded pic and let me know. Any help is appreciated. Thanks

This handle appears to be stripped, and no longer engaging with the gears

Can you please tell me what part I need to order. I need 12 of these

Hi Do you have a weatherstrip for a Stanley door 32X80 Left hand swing Steel door, I can not find a part number

I have these 2 screws in the middle the one isn't moving. It's the lower one. Anyone know what it is or how to remove it? Its preventing me from moving the balance/show to the opening. Od like to not to have to cut the track or spend 300 on jamb spreaders ill use once.

It is a sliding closet mirror door with the piece being a top mount. The only tag on the product itself is shown in the attached pictures above. The part needed is the broken plastic piece shown which holds the mirror door from the top and keeps it in place.